musmecca's latest activity
-
MI think you can start with a 0.39µf and then go with smaller if needed. we can eliminate the low component with an R in // to make an...
-
Mmusmecca replied to the thread Home-Made IEMs.Any thoughts on single HP cap value for the RDU dual super tweeter? I'd ideally like it to cut at 6-7k as it doesn't appear the RDU does...
-
Mmusmecca replied to the thread Home-Made IEMs.yep...that's the price for 1. Only good thing is they are not counterfeit or used!
-
Mmusmecca replied to the thread Home-Made IEMs.Anyone have a datasheet for the Knowles RQU35066? I can't find one anywhere and I have some samples. Also....what is the purpose of the...
-
Mmusmecca replied to the thread Home-Made IEMs.I do...I've got it written at home. Give me a day as I'm travelling...
-
Mmusmecca replied to the thread Home-Made IEMs.I've used the HE quite a bit. Its very easy to work with and I've added est65's for sparkle and hodvtec's full range, no cap or resistor...
-
MDef you have to switch green cable of the 2389 to the other pad - leave the yellow at half coil as is just move the green one to the...
-
Mmusmecca replied to the thread Home-Made IEMs.Yes you can tell if polarity is wrong because the graph will appear "notched" as above. If you are listening to it, it will sound as...
-
Mmusmecca replied to the thread Home-Made IEMs.I don't know the mic, but what the HELL was he doing with the vent?? It looked like he was tuning the BA and feeding the output of the...
-
Mmusmecca replied to the thread Home-Made IEMs.When I've used the sonion est's, I've used them in conjunction with other tweeters. I use a highpass so I'm not wasting energy (normally...
-
Mmusmecca replied to the thread Home-Made IEMs.The short answer is you will still need a tweeter/fullrange in conjunction with an RAU. It appears (per the graph) that it doesn't hit...
-
Mmusmecca replied to the thread Home-Made IEMs.No stone for me...
-
Mmusmecca replied to the thread Home-Made IEMs.I use the carbide rounded bit as it doesn't clog up with material...I then hit it with the sanding disks for use with the dremel...
-
Mmusmecca replied to the thread Home-Made IEMs.Oil from fingers is not water soluable....