what is the consensus on knob size from partspipe?  gotta get around to ordering one

finally got around to doing the last bit of wiring and pcb cleaning (ugh what a pain) and the initial bias setup and it works :D   now to just let it warm up to set the final bias and then we'll case it up

nah those I got based off the pics on diyforums...the stuff I asked about were things I couldn't make out in the pictures also pcb is stuffed just need to clean it and wire and bias it

awesome, thanks yet again

yah for the most part the entire thing is paint by numbers just a few things that I don't know   also same question regarding PF1 likely doesn't have orrientation but want to check before I blow it up if it does :D

now that you mention it I can see the silkscreen showing it's orientation now as well lol chalk that one up to it being far too late

Quote: Originally Posted by tomb Use the 10R. That's the best all-around choice. Don't ever use anything as high as 47R or 100R if you're interested in performance. It will really cut back the detail. A couple of caveats are that some people have detected a bit of hiss when using...

finally getting around to building my minimax and despite everything I've read I'm still confused about just what to use for RB14 I'll mainly be using this amp with my sr225s and vtg10's so I'm not sure if jumpering it would be best or if I should use either the 10r, 47r or 100r kiwame's I've...

i'd likely be interested in an extra psu or two if and when all the kits are gone and the extras remain to be sorted

Technical books online Neets Module 06-Introduction to Electronic Emission, Tubes, and Power Supplies

what are you using for the actual switches? I'm looking to build something similar myself but am terrible at actually sourcing parts.

kinda looks the same as emotiva stuff

i might have missed it in this thread but what are we looking at for price to build one of these?

"It's not my revolution if I can't dance to it." bonus points if you know who i'm quoting

Quote: Originally Posted by tomb Assuming your meter is OK, that measurement across R9 explains a lot. The voltage leg for R9 and the LED are taken directly from the USB power connection - no regulator involved. This means you're only getting about 3V (2.65 + 0.36) from your USB power...