Yeh i didn't use anything worth much for testing. First i tested it with some very cheap phones, then with my Speedlink Medusa's. I don't care if they get fried It's the Medusa's that i'll be upgrading to the Beyer's. When i got them i was about 15 and was drawn in by the 5.1 aspect of them...

Hey guys, nobody's a dumbass. It was connected on the bottom because it was hard to get it underneath the blue cap. I fixed this just now anyway. Relocated it to the top where it should be. T'was i that were the dumbass. Anyhoo, i got it working!!!! So pleased right now. To fix it i did a...

Quote: Originally Posted by shortkidsrus It looks like the yellow output wire is attached to the wrong pad. It looks like it is bridged with a bunch of solder, but you might want to move it one pad up (toward the power source) so it is on one of the pads shorted by the M-jumper...

Funnily enough, i found my pot of flux after i had finished soldering everything

Cheers for the help. Pars, when you say 'ohm it out', which points do i actually have to measure from? Pins 6-7 or from pin 6-gnd and pin 7-gnd? Sorry, complete electronics noob here! Uncle Bob, i thought it might be something to do with my shoddy soldering skills . I was planning on...

ok here's the two pictures, sorry for the quality. The side with the yellow cable is the one that isn't working. Also, i know the colours of the cables is confusing. I accidentally got the colours mixed up and cba to change it

Hey guys. I decided to build my first CMOY recently after reading up about it for a while on Tangent's site. I followed his tutorial exactly and bought pretty much exactly the same parts/board etc. I plan on getting some Beyerdynamic DT770's to use on it. I have never soldered anything...