Recent content by JBThazard
-
New model Cowon - Plenue D2
I have the strangest problem with the D2. The volume setting goes all the way to 140 but it caps way before that. As far as I can tell, 108 is the max and it doesn't make any difference past that. Does anyone else have this issue?- JBThazard
- Post #925
- Forum: Portable Source Gear
-
Maverick Audio Tube Magick D1 Plus Replacement
Looking for a new full size dac/amp/preamp combo as my D1 is getting old. It should preferably have line-in for my DAP and USB dac output for my PC as that's what I mainly use. Similar price point as the D1, so $200-$300 but a little more expensive is fine. I use Senn HD600 and Monolith M1060.- JBThazard
- Thread
- Replies: 1
- Forum: Introductions, Help and Recommendations
-
Question about DAC Filters with Cowon Plenue D2
I recently just got a Plenue D2 and while I really like it, I have a question about the DAC filters setting. What do these do, exactly? Because I was expecting it to have as noticeable a change on the sound as the EQ but I can't really notice any difference. There are 5 settings: Fast / Low...- JBThazard
- Thread
- Replies: 1
- Forum: Portable Source Gear
-
Looking for closed-back headphones (balanced)
I've been using the Beyerdynamic DT1350s for a couple years. i like them a lot though they may be too "neutral/clinical" for some, which is why they aren't my main cans. They have good mids. Not especially warm, but not bright either.- JBThazard
- Post #3
- Forum: Introductions, Help and Recommendations
-
Sparkos labs Discrete Op-amps causing squeaky-static noise in headphone amp
Any tips on I what can do? 2 of them sounds great but I'd really like to use all 3 for maximum impact- JBThazard
- Post #3
- Forum: Introductions, Help and Recommendations
-
Sparkos labs Discrete Op-amps causing squeaky-static noise in headphone amp
To cut to the chase, I use the Maverick Audio Tube Magic D1 Plus Headphone Amp + DAC and just today got three of Sparkos Lab's Discrete SS3602 op-amps, but there's a problem. One of my three opamp slots is causing an issue. If I plug in one of the discrete op-amps into this slot, there is a...- JBThazard
- Thread
- Replies: 3
- Forum: Introductions, Help and Recommendations
-
Need replacement cables for Monolith M1060
Long story short, I've owned these headphones for half a year and the stock cables are terrible. I have the revision 2 M1060s and they have dual 2.5mm that plug into the cans, and a 3.5mm for headphone amps, etc. So what are good but not expensive replacement cables?- JBThazard
- Thread
- Replies: 0
- Forum: Headphones (full-size)
-
Need Help with scratchy volume knob on headphone amp
I see, never considered that. I've had the same tube for about 3-4 years now, could it be getting too old? I was actually planning on upgrading to a Tesla 6CC42 pretty soon- JBThazard
- Post #9
- Forum: Introductions, Help and Recommendations
-
Need Help with scratchy volume knob on headphone amp
Yes, I removed the top lid of the case and sprayed the cleaner around the BK100 connector thing that's attached to the knob. I noticed that some static was reduced so it definitely cleaned something out, but I still get that right channel cut-off or the scratching noise while turning in certain...- JBThazard
- Post #7
- Forum: Introductions, Help and Recommendations
-
Need Help with scratchy volume knob on headphone amp
So I borrowed some contact cleaner from a neighbor and try to see if that fixed the issue but it didn't. I think there's less of a "static" sound now but the crackling noise still happens when I twist the knob, still looking for someone to teach me to remove the knob and get to the bottom of this- JBThazard
- Post #5
- Forum: Introductions, Help and Recommendations
-
Need Help with scratchy volume knob on headphone amp
Haven't tried any contact cleaner, I want to unscrew the knob from the Bk100 and see if I can clean it or screw it back into an optimal position- JBThazard
- Post #3
- Forum: Introductions, Help and Recommendations
-
Need Help with scratchy volume knob on headphone amp
I have the Maverick Audio Tube Magic D1+ and for a while now the volume knob creates a crackling or scratching noise when I turn it. I tried a lot of different advice, like turning the knob with the amp off or opening up the case and dusting it out, but none of it has worked. I think the...- JBThazard
- Thread
- Replies: 10
- Forum: Introductions, Help and Recommendations
-
Monoprice Monolith M1060 and M560 Planar Headphones
My headband snapped and I want to buy a new one. What are the best replacements I can get for M1060?- JBThazard
- Post #7,799
- Forum: Headphones (full-size)
-
Monoprice Monolith M1060 and M560 Planar Headphones
That was my suspicion too. Thanks for all your help, I've been desperate to fix this issue Edit/Update: ZMF already emailed me back, they confirmed it's the same pad- JBThazard
- Post #7,516
- Forum: Headphones (full-size)
-
Monoprice Monolith M1060 and M560 Planar Headphones
Okay I see. I checked the ZMF website, which kind of pad is going to be better? I'm stuck between these two, as you can go with suede with eikon pad type, or eikon with suede pad type http://www.zmfheadphones.com/pads-and-cables/zmf-suede-earpads...- JBThazard
- Post #7,514
- Forum: Headphones (full-size)