Recent content by illumidata
  1. illumidata

    Precog's IEM Reviews & Impressions

    I'm guessing it could be something truly awful
  2. illumidata

    DUNU - Discussion/Impressions Master Thread

    Admittedly it's an HBB graph, so unlikely to fully reflect anyone else's measurements, but I think overall balance has strayed into mudcannon territory :frowning2: The mid treble shelf seems to have been replaced with a resonance peak, boosting the bass is just adding distortion and the mids...
  3. illumidata

    DUNU - Discussion/Impressions Master Thread

    On the assumption this was released to promote discussion...I really hope this isn't the finalised tuning.
  4. illumidata

    DUNU - Discussion/Impressions Master Thread

    My travelling companions for the last few days: :flag_mx:
  5. illumidata

    DUNU - Discussion/Impressions Master Thread

    I used a Cyanoacrylate adhesive (usually referred to as "superglue") which requires only a very thin film. Just went back to the set I glued (was about a year ago) and tried really hard to pull the nozzles off both the one I fixed and the one with original factory glue...neither came off, fwiw.
  6. illumidata

    DUNU - Discussion/Impressions Master Thread

    If you dig deep enough you will find QC issues with every set on the market, glue related or otherwise. E.g. this has happened to several people's s12s You could get a 3d printed set (but even those could use glue for the connectors). On the plus side it will be fine if you glue it back...
  7. illumidata

    The Qudelix-5K thread

    The 5k works very well as a mic when hung from the neck. I have it paired with my laptop and phone and it will switch seamlessly between the 2 sources (just remember to switch off music on the phone before launching a call/WebEx/etc from the laptop - nasty crackling sounds will ensue before the...
  8. illumidata

    Beyerdynamic Xelento!

    I had to file mine down a little (a very, very little, just on each vertex). Also you have to insert them dead straight - I think Beyer must use a machine to get them on and the tolerances are just too tight for hand fitting. GL!
  9. illumidata

    Beyerdynamic Xelento!

    I would be very wary of used Xelentos because of all the fakes out there.
  10. illumidata

    The Head-Fi Members' Poll for IEMs - 2022

    Best single-DD or single Planar IEM Less than $10 Sony MH755 $10-24.99 CCA CRA $25-$49.99 Blon BL03 $50-$99.99 KBear Diamond $100-$199.99 Dunu Falcon Pro $200-$349.99 Tanchjim Oxygen $500-$999.99 Beyerdynamic Xelento $1000 - $1999.99 Campfire Audio Supermoon Best all-BA or all-DD IEM...
  11. illumidata

    Reply to review by 'illumidata' on item 'DUNU Talos'

    I'm giving this review 5 stars, so well structured, and spot on impressions. The percussion/micro detail issues are almost entirely fixable with EQ, turns out there's a ton of detail being masked by the mid treble peaks but out of the box the top end is indeed a bit of a mess...but I think it's...
  12. illumidata

    Subtonic STORM: Impressions and Discussion

    Question please - has the tuning changed from the demo version that was at Canjam London in July? This graph "looks" like it has had the bass boosted a bit. Also congrats on getting this far and good luck with launch!
  13. illumidata

    DUNU - Discussion/Impressions Master Thread

    No free shipping to UK below $300 from Hifigo, but taxes are pre-paid. I think it's free over $100 to Asia & USA. There's a $10 option as well that's a bit slower...I could have maybe found a better deal if I'd waited but would have risked being stuck in the inevitable 11/11 traffic jam. :unamused:
  14. illumidata

    DUNU - Discussion/Impressions Master Thread

    Thanks Maestro, been waiting for this post ;) Dunu #4 incoming!
  15. illumidata

    DUNU - Discussion/Impressions Master Thread

    @Sebastien Chiu Just by way of a heads up - Hifigo still have Ultra listed but the option defaults to the OG SA6. Seems like a trap for the unwary...
Back
Top