if you wanted to spend a while researching, you could build a cmoy pretty easily for 30 bucks I'm using a jung multiloop topology amp (almost a meta42) w/ my dt770's hmmm though, I still haven't noticed an inability for my cdp's to power them w/ or w/o amp. no complaints here -Hype

Hmmm, I 've had a pair of these cans for a week now. And, w/o some sort of bass boosting, I really don't think the lower end is over emphasized. Thats from listening to mostly rock/metal this past week. I'll admit though, on a few rap recordings I can really relate to the talk about its huge...

on markertek's site, whats the difference between the 3.5mm mini-mini cables and the 3.5mm Balanced (Sterio) mini-mini cables? SC6MM - 3.5mm Mini Male To 3.5mm Mini Male Audio Cable SC6MZMZ - Balanced (Stereo) 3.5mm Male To Balanced 3.5mm Mini Male Audio Cable -Hype

OMG!! ROFLMAO ~ those are huge ^^; I feel better about the size of my cans now =] thanks for the help last few mins gerG

heh gotta love it I'm not sure how big the dt770's are in comparison, but they are bigger then I expected ;D I'm getting used to them though atleast you have a setup you enjoy -Hype

well if it wouldn't take too long that'd be great gerg thanks

Hey guys, I just got a pair of these this week, sound good so far. But I was wondering, should they have little bits of fuzz on the ear cups? Its like carpet fuzz for lack of a better example. And if yours had it when new, do the cups wear thin spots earlier than one might expect? Its only...

If you didn't split your voltage well, then a higher total volts would help it sound better, if not then I doubt it would matter. IE running off a 9v but ending up with -1.5V and +7.5V, the -1.5 wouldn't be enough to power the opamp and it'd distort. But if its 4.5/4.5 then it'll have enough to...

Sorry for hijacking your post ;P but does ad8620 come in DIP packages? I'm only seeing SOIC EDIT: bah nm I just read another post, needs an adapter -Hype

post part #'s so you can get some real help. those "2 connecters" on the side of the pot arn't connecters if I'm not totally off. Only the 6 in a row are. Search other posts on how to wire it. for the power switch, the (+) wire from your board goes to the middle pin, and the (+) wire from...

sounds great Probably a good step above my multiloop one ;P I got the dt770pro's shipping to me right now =] I think this amp will sound great with them. my next project is a simple low z mod linkwitz. the damn switch is half the cost of the whole project ;D but it should add another...

always check the opamp's datasheet to be sure, but for op amps like opa2132 and ad823, thats correct. Make sure you notice where the notch is, as that is *slightly* important lol -Hype

eh same problems I had with angelfire and geocities lol, lots of ppl completing amps lately gw -Hype

alright, simple enough thanks you two now I have a use for this penguins tin I bought =] -Hype

I saw that you were making your way around the posts voodoochili ;D Lemme see if I understand at all, put all the grounds to some common place on the board, then link the in/out jacks to it, and it uses the gnd from the amp?? that'd be easy if thats the case. how close(or off) am I...