Recent content by discus123
  1. discus123

    Home-Made IEMs

    ok, I'll try it tomorrow. thanks mattmatt
  2. discus123

    Home-Made IEMs

    The come out of the shell is very good, no more that extra layer of cured resin inside the shell. It is smoother and more finer than previous printing. Thanks Aldo40, your way of putting the shell is the best and I have no need to make an additional hole to drainage away the resin. I can't...
  3. discus123

    Home-Made IEMs

    Here is the 3D printer layouts and settings
  4. discus123

    Home-Made IEMs

    I'll show you while I back home. thanks mattmatt
  5. discus123

    Home-Made IEMs

    thanks your advise. I will make change and print the shell again. Do I need to change the printer setup also. please take a look for me, Layer Height = 0.03 mm Exposure time = 8 seconds bottom layer count = 5 bottom exposure time = 30 seconds anti-aliasing = 5 Lift total height=4 Lift speed=...
  6. discus123

    Home-Made IEMs

    This batch of shells just taken out from my 3D printer this morning, it seems quite smooth and solves all my probelms facing in previous printing. In here I thank bro mattmatt for his big big helping. You're kind and generous indeed helping me a lot. thanks bro !
  7. discus123

    Home-Made IEMs

    Nice build. Excellent ! What kind of uv resin you used ?
  8. discus123

    Home-Made IEMs

    I totally agreed with you. You are right ! we're on the same boat.
  9. discus123

    Home-Made IEMs

    I planned to buy a 3D uv printer also. Which one is better and have better quality ? About 3D scanned, how ? and use what kind of software to scan the shell ? Thanks..
  10. discus123

    Home-Made IEMs

    I used this as my sample to fine tune my set of BAs. 38AM at start I used 20R but bass too much. I then added by 10R plus another 10R, the final FR I used is 100R. I guess the tube length for 38AM is too short, it needs to add at least 4-5mm more. I have tried L-pad also, it did lower the...
  11. discus123

    Home-Made IEMs

    How about the damper ? What color for the Low, Mid and High ?? Thanks !!
  12. discus123

    Home-Made IEMs

    I like the purple one. Nice color.
  13. discus123

    Home-Made IEMs

    Terrific !!!! I wish i was your friend.
  14. discus123

    Home-Made IEMs

    Wow ... Excellent
  15. discus123

    Home-Made IEMs

    very pretty, good job !
Top