I'm still new at this but I've tried glueing drivers in the Shell with uv resin which for now hold fine, I use a small syringe to place drops.

After 3 months of learning reading and gathering information on diy iems I finally made a pair from scratch, I went with a hybrid build for my first one and I'm happy with the results. I did pause for a 2 weeks and today I completed a somewhat bass heavy set with good stage and clean highs. I...

I believe it's the 3800 series 38d1xj007mi that has a ferrofluid

Hi everyone I have been following the forum for a while now and I've been learning at lot about designing iems, I started with preassembled ba's with custom shells but now I'm looking to put together all components and make something better with more bass and nice resolution. I bought a few ba...

I was hoping to see a diagram of this set up I'm stuck with how to wire those drives, (+ - )/(+ +) (- -)? And if I wanted to keep the 2389D as a mid and throw in a swfk

How did you wire the 2389D, I got a fresh pair and not sure if middle tap is used on the dual ba or if it's series or parallel.

Do you have a crossover and damper recommendation for this set up , I'm new at this with individual components, I did build a preassembled 3ba 31732 with dampers but micro soldering is new to me I'm using smd's caps and resistors.