akatsuki's latest activity
-
akatsuki replied to the thread Tofty's DIY Headphones - 3D Printed.Hey. I was looking through the maxx HD800 mods thread and wondering if any of those things are applicable here. Like let’s say I isolate...
-
akatsuki replied to the thread akatsuki's Aurora Borealis clone.OK - finalized the design pretty much. Filled in the instructions and may add a simple wiring diagram later.
-
akatsuki replied to the thread akatsuki's Aurora Borealis clone.@Tofty the other design I mentioned above seems to be better. I am redesigning it some and I did include a larger "tunnel" for a wire to...
-
akatsuki replied to the thread akatsuki's Aurora Borealis clone.OK, the other band (for the Koss) seem to work reasonably well. I am going to redesign them after some thought and try and combine a...
-
akatsuki posted a comment on classifieds listing 64 Audio U12t - MINT.PM
-
akatsuki replied to the thread akatsuki's Aurora Borealis clone.@Tofty I would say that the Armadillo headband does not work at all - like it makes me question whether anyone actually printed and...
-
akatsuki replied to the thread akatsuki's Aurora Borealis clone.Reserved
-
akatsuki replied to the thread akatsuki's Aurora Borealis clone.Here is the near final 2-piece version: https://www.tinkercad.com/things/8fLQdb0w79o It is designed to be as easy to assemble as...
-
akatsuki posted a comment on classifieds listing Audio-Technica R70X.Pm
-
akatsuki replied to the thread Tofty's DIY Headphones - 3D Printed.So snapfits break too easy unless you are willing to do a lot of work becaue of the layup direction, going to kill those designs. Maybe...
-
akatsuki replied to the thread Tofty's DIY Headphones - 3D Printed.Okay - I thought about it and realized I was massively over-complicating it. I am revising the design so that you have two pieces and...
-
akatsuki replied to the thread Tofty's DIY Headphones - 3D Printed.This is a WIP version: https://www.tinkercad.com/things/7HLxxGZLlRg To make this one work, the jacks need to go onto the driver clamp...
-
akatsuki replied to the thread Tofty's DIY Headphones - 3D Printed.Here is an assembled pic of an draft iteration of my Aurora - still waiting on headband. The main difference is the earpad plate and...