-
-
@tonybuild all three cross components look like great starting points. Couple of things I always watch for when working with these two... -
GeneBush replied to the thread Home-Made IEMs.It's been 5+ years that i'm into DIY CIEM and it never happened to me while i was building my shells the "Old" way. No, tubes are not...
-
GeneBush replied to the thread Home-Made IEMs.I get a higher peak at 6khz and a drop from 7-12khz when i install them in the shell
-
GeneBush replied to the thread Home-Made IEMs.They're composed of 38d1x 2nd order low pass dual yellow dmp 22mm 1.5 ID tubing Rab 32257 2nd order highpass orange dmp 22mm 1.5 ID...
-
-
GeneBush replied to the thread Home-Made IEMs.My shells are haunted!🤔🤯 Did it happen to any of you guys that you do a good crossover, with a good set of drivers and it sounds good...
-
GeneBush replied to the thread Home-Made IEMs.Then you have to find an Otorhinolaryngologist (ENT Doctor) to do it but actually I'm kinda surprised that the audiologist won't do it.
-
GeneBush replied to the thread Home-Made IEMs.You need some new impressions my friend, these are poorly made but before you should consider a proper clean of your ear canals by a...
-
Cleaner looking build that is. I recon lots of small components are easier to fit in a shell than one large one.
-
so far the only place ive found is this taobao store. youll need to use a service like superbuy to get it if you arent in china tho. you...
-
GeneBush replied to the thread Home-Made IEMs.Hey man where did you find the Rau from knowles? Any link will be appreciated! Thnx in advance!
-
GeneBush replied to the thread Home-Made IEMs.It all depends on how accurately you scan the impressions. It's a bit difficult to get the right lighting and the scan software is still...
-
GeneBush replied to the thread Home-Made IEMs.I used to have the revopoint pop2 but i exchanged it with someone who had the mini. The difference between the 2 scanners is notable...
-
-
Planning to get that too. :D mind sharing photos of your scans?
-
GeneBush replied to the thread Home-Made IEMs.REVOPOINT MINI here. It rocks
-
GeneBush replied to the thread Home-Made IEMs.Hi guys! I found out that the 4 drivers LS FWEK-42017 are the same as the one used in Bellsing 6 and have the same crossover. I have...
-
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
