You can use 1 opamp for a buffer. There is a section in this article about distribution amplifiers. http://headwize.com/projects/opamp_prj.htm Here is the picture.

Make sure that you heat the wires or leads and not the solder, and you should be fine. I wouldn't wory about it unless its causeing problems, or your joints start falling apart Most of my cold joints show up pretty quick, this may be due to my lack of solder skills. Good luck. -c

Yes, I was looking for this type of pot specificaly. Its for tone control. I think I may try that 500k one in erix post. I would rather have a lower value, like 320k. or 250k, but I think that it will work. Anybody else have any other places? Thanks for helping guys.

Here is a picture.

I don't have a very extensive shopping base, but I need a concentric(stacked) pot. I have looked at digikey but have not found what I am looking for. I am wondering if anybody here knows where I might aquire one of theese. -thank you.

Will you use all 4? 2134's? The 47 should only use 2 of them, and if you would be kind and share the wealth I would apreciate it But I will totaly understand if you don't. If you share I will most defenitaly post picuters. Thank You -cp

Simplify. Bypass the jacks and just touch the wires to the plugs. Bypass the pot if you are useing that. Take out all the extra stuff and start jumpering wires. Bypass the last resistor. Don't give up. It will be well worth it once you finish. -chronicP.