-
-
tonybuild replied to the thread Home-Made IEMs.Man , thank you . Speaking of myself, i try to remember as much i can , but lots of time i just forgetting the stuff i learned here... -
2x22uF in parallel together will make 44uF :) (and 2x22uF in series would make 11uF) so you can solder 2 22uF together and you have 40...
-
This is not the only strategy. I have run caps to positive terminals in certain configurations. A single series capacitor will not...
-
tonybuild replied to the thread Home-Made IEMs.Lol I don’t know what is leakage Whatever you say, I’m for it:)
-
He is referring to polarity inversion, also referred to as phase inversion. Ie. Connecting the positive wire to the negative terminal...
-
tonybuild replied to the thread Home-Made IEMs.It 38d1xj . I used 20 ohm resister on it . I like the volume of it . Also I reverse the polarity on 38 . I thought I don’t need it...
-
-
tonybuild replied to the thread Home-Made IEMs.thats what im about to do as well:)
-
tonybuild replied to the thread Home-Made IEMs.Thanks man! Im really bad with math, sometimes when im confused, i just trust my ears . What if i wire one 2389 center tap, and other...
-
You need to do some calculations to understand where you are first, otherwise you are going in blind. 22uF 2389 (single, no center cap)...
-
tonybuild replied to the thread Home-Made IEMs.Do you think I should wire them separately? Also,should I always run caps with positive? Because on the graph 📈 I don’t see difference...
-
Lose the center tap - connect normally - this will give you more mids as your crossover will move an octave down. 2389 is already very...
-
tonybuild replied to the thread Home-Made IEMs.yeah, i noticed that even when you cut 2 mm off, it shows big difference.
-
tonybuild replied to the thread Home-Made IEMs.I’ve changed it. I just ran negative terminals separately with cap . Middle stays the same. Also, i do feel i need lil more mid...
-
12mm @3mmOD. You can use a series resistor before the cap to lower volume of each 2389 driver in the 2389D config. 5-10ohms usually helps.
-
tonybuild replied to the thread Home-Made IEMs.O interesting:) 12 mm tube or 14 mm ? I tried 14 mm , and its seem to working. Lil bit loud
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
