-
-
2359glenn replied to the thread 2359glenn | studio.Take a picture of the underside and send it to me. -
2359glenn replied to the thread 2359glenn | studio.I will send you a PM
-
2359glenn replied to the thread 2359glenn | studio.Output impedance about 60 ohms. Tube rectification ether mercury vapor rectifiers 866 or 3DG4,5AU4 or 5CU4 rectifiers. The mercury vapor...
-
2359glenn replied to the thread 2359glenn | studio.The 5CU4 is a great tube low voltage drop high current. Most amps can't use it but yours can. A bit hard to find though. Glenn
-
2359glenn replied to the thread 2359glenn | studio.Glad to talk to you guys again. Have to build some amps to stop me from going crazy. In hospital for months takes a toll. Being bed...
-
2359glenn replied to the thread 2359glenn | studio.5CU4 is a great rectifier tube for the OTL but draws over 3amps filament current might overheat the transformer in other amps.
-
2359glenn replied to the thread 2359glenn | studio.I will get that amp back to you. My problem now is I am to feeble to pick the amp up in the box. I will make no more amps with 3...
-
2359glenn replied to the thread 2359glenn | studio.Hi Have you taken the bottom off? Might have a bad plate resistors on the 6SN7. At a point I thought that boutique parts would be...
-
2359glenn replied to the thread 2359glenn | studio.Hi All I am back somewhat feeble now but plan on working on amps again in a limited amount. Designing a OTL amp that will drive the...
-
2359glenn replied to the thread L0rdGwyn's DIY Audio.Hi Everybody Happy Thanksgiving Been gone for awhile due to health issues Have a great weekend
-
2359glenn replied to the thread 2359glenn | studio.Armacost Lighting Quick Connect Terminal Block (3-Pack)-920030 - The Home Depot
-
2359glenn replied to the thread 2359glenn | studio.It only hurts for a second ! Try some of these cut one off then cut the wire stick one wire in one side one in the other ant tighten the...
-
Since there's not much of interest on TV here in the states this evening, decided to try a new roll. Mullard GZ32, six 6N12S and a pair...
-
Well, for those who might have some interest in rolling C3g... I'm currently enjoying rolling different drivers and rectifiers with a...
-
Hast du mir gesehen - you found a really nice combination here! Don't have Lorenz C3g but put in an old pair of Siemens with embossed...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
