[FraGGleR]

I got a great deal on a used Metcal SP200 just in time for an amp build (Objective 2).  I have a standard conical 700F tip on it and was wondering if there was a better size or geometry for doing circuit board stuff.  Reading through some old threads I understand a flat (screwdriver) is good for board work, but not sure what size or temp.  I haven't worked with a "smart" iron before so was looking for some guidance.  Thanks!
 
Linked below are the tips that are available to me:
 
http://www.okinternational.com/product_soldering/sp200#tipgeom

 

[MisterX]

The cartridge you have is fine.
Conical Vs chisel is a personal preference, don't get to hung up on it.

 

[FraGGleR]

Thanks MisterX. Will give it a shot with what I have.