Review Decware Taboo. An Amazing Achievment
But there seems to be posts saying a speaker load is required when it isn't for the amps health just as long as headphones OR speakers are attached is all that matters.
I generally leave the HP plugged in, but I never had trouble with the Taboo MK III either way.
I was referring to the Taboo MKII.
I was referring to the Taboo MKII.
Francoy
100+ Head-Fier
- Joined
- Sep 11, 2010
- Posts
- 151
- Likes
- 19
Argo Duck
Formerly known as "AiDee"
- Joined
- Nov 6, 2007
- Posts
- 2,245
- Likes
- 433
IIRC the topic has been well covered in this thread - use search this thread. If not here, then in the Taboo III thread.
And IIRC low values were recommended - 8 ohms or thereabouts.
Well worth checking out as well are posts from Steve himself.
FWIW, I run my LCD2r1 or LCD3F direct from the speaker taps without any extra load and noticed only improvement compared to using the SE hp jack. If only listening casually I leave the speakers connected. I do always take care to have either speakers or phones plugged in when the amp is on.
And IIRC low values were recommended - 8 ohms or thereabouts.
Well worth checking out as well are posts from Steve himself.
FWIW, I run my LCD2r1 or LCD3F direct from the speaker taps without any extra load and noticed only improvement compared to using the SE hp jack. If only listening casually I leave the speakers connected. I do always take care to have either speakers or phones plugged in when the amp is on.
From 4ohm to 16 ohms I think using 5watts I believe - they make a minimal difference but a difference.
7.5 ohms are good with LCD-3
gug42
500+ Head-Fier
- Joined
- Jan 29, 2008
- Posts
- 519
- Likes
- 32
Hello,
I have a wa6se. And well any opinion about the Winged C 5U4G Rectifier ?
I have a wa6se. And well any opinion about the Winged C 5U4G Rectifier ?
Users who are viewing this thread
