TypodCrowd
Member of the Trade: Modder
Does anyone have pictured of what this lead to?
Hello,I'm not clear on all the details, Kevin if you could help me
The Nanotube is a SiC Circlotron from what I understand.
- Is this the latest known working PS board?
circlotronhvpowerdualnewer2.ZIP
- Is this the latest known working output board?
kgsshvcarboncirclotron.ZIP
- And latest known working driver board?
kgsshvcarboncirclotrondriver.ZIP
- Are these ready for experienced DIY?
- Who supplied your trafos? Any special notes
- Any special build notes other than
- single chassis as we're near kV
- mil-spec teflon wire
- HV DMM probe
- ceramic heatsink standoffs where needed
- lift resistors
- any special component notes - resistor/cap specs?
Thanks so much, as always I look forward to the build
Edit: For reference Kevin's notes
complete production board set (ok, I forgot the stax jack board)
http://gilmore.chem.northwestern.edu/circlotronboardset.jpg
Hello,For those interested, a few sets of Circlotron boards from the Group Buy at 'the other place' is available here
All PCBs are from PCBNet: 3oz copper (ALL boards to build the Circlotron is included)
4 x HV900 Golden Reference High Voltage Power Supply boards
2 x Driver Boards
2 x Output Boards
1 x Split Golden Reference High Voltage Power Supply includes BIAS supply (580V)
1 x Split Golden Reference High Voltage Power Supply includes low voltage supply
16x 470uF/550V, for the HV900 batteries
4x 680uF/550V for the HV PSU
(This is excess from a recent Group Buys, so not a whole lot in stock)
The kit can be used for building a KGSShv Carbon, as the driver board is almost similar to the Carbon v5 amp board although it takes a few tweaks in rgrds to servo and feedback loop.
/S
I'm not clear on all the details, Kevin if you could help me
The Nanotube is a SiC Circlotron from what I understand.
- Is this the latest known working PS board?
circlotronhvpowerdualnewer2.ZIP
- Is this the latest known working output board?
kgsshvcarboncirclotron.ZIP
- And latest known working driver board?
kgsshvcarboncirclotrondriver.ZIP
- Are these ready for experienced DIY?
- Who supplied your trafos? Any special notes
- Any special build notes other than
- single chassis as we're near kV
- mil-spec teflon wire
- HV DMM probe
- ceramic heatsink standoffs where needed
- lift resistors
- any special component notes - resistor/cap specs?
Thanks so much, as always I look forward to the build
Edit: For reference Kevin's notes