[BotByte]

This is an easy one, but difficult at the same time.
 
So I got two Mods going on.
 
Grado SR80i re-cable with two mono inputs on each cup. I don't want to drill for a stereo and cable cross over.
So this one would need a cable, prefer 9ft, 3ft to play with, that I can split to two mono 3.55mm males. Then I would need enough cable to connect from the 3.55 mono to driver. Not a problem.
 
Then I'm getting some Fostex T50RPs that just need a 3.55mm male Right angle prefer to 3.55mm male cable. 6ft long.
 
I would rather buy them already assembled, I could probably find the T50RP easily. I can custom make cables, I'm good with electronics
 
I'd like to spend $50-100
I have most big box stores in my area including: Radioshack, Bestbuy -_-, and Fry's
 
 
Shopping list I see:
2 x 3.55mm mono female
2 x 3.55mm mono male
1 x 4 wire headphone cable with sleeve
1 x 3.55mm Stereo male
1 x 3.55 right male to 6ft cable to 3.55mm male
Soddering iron
Multimeter
Sodder
Shrinky rinky cable covers thingys - Heat Shrink
Cable sleeves
 
 
This is a lot of info for you, but this is all you need to know:
 
WHAT SITE DO YOU LIKE TO BUY THIS STUFF FROM AND WHAT CABLES ARE GOOD AND CHEAP?