"After a very long period of development and fine honing of our skills IMR is delighted to announce our range of custom in ear monitors.
Offering the ultimate in fit, comfort and isolation to get the absolute very best from your music.
Building on our spectacular Elan, Astra Ultraque and Pro models to offer an even more personalised experience.
Using our CNT ADLC wide band dynamic driver tuned for custom in ear monitor duties with a multitude of additional driver options including our highly specialised AMT (air motion transformer) driver option for those that demand the ultimate.
The Stingray would not be an IMR product without the ability to change something on the IEM and the front plate can be changed from an open port design to a fully closed design allowing you to run a larger staging open port or fully isolated in closed.
Which ever driver combination you chose you will always enjoys a rich and realistic low end, lush and intimate vocals and midrange with exceptional highs.
Available in either comfort fit for all day comfort use or stage fit for those that need absolute security while performing on stage.
- STINGRAY I - The Elan in custom form. - CNT ADLC + Bone conduction.
- STINGRAY II - Astra Ultraque in custom form. - CNT ADLC + Bone conduction + Dual electrostatic drivers.
- STINGRAY III - Based off the Astra Ultraque with dual balanced armatures for added vocal presentation and placement. - CNT ADLC + Bone conduction + Dual electrostatic drivers + dual balanced armature.
- STINGRAY AMT I - Utilising a AMT driver for upper midrange and upper registers combined with our CNT ADLC for ultra realistic and effortless presentation.
- STINGRAY AMT II - The same as AMT I but with bone conduction to add additional layering, detail and staging while putting you even further immersed into the music.
- STINGRAY AMT III - Combining AMT II with dual electrostatic drivers for ultimate resolution, imaging and stage beyond what you though was possible with a IEM.
Why chose an AMT equipped IEM? AMT drivers work quite differently to other drivers and due to the pleated diaphragm act like bellows rather than using vibration or pistonic motion. They are exceptional at their duties without shouting about it, wont run out of headroom with exceptional transient response. Never too bright or hard but precise.
Stingray I,II,III all require up to 60 day build time from the receipt of your ear impressions or 3D impressions file.
Stingray AMT I.II,II all require a 90 day build time as all AMT drivers are hand made and require much more time to build.
All are supplied with 2.5mm, 3.5mm and 4.4mm cables, adapter and carry case.
ALL custom models are non refundable as they are made to fit just you.
All prices exclude UK VAT and VAT will be added at the checkout for UK customers."