- Joined
- Apr 12, 2004
- Posts
- 8,216
- Likes
- 817
5/20/07 - Impressions now over - formal amp review thread to follow later this summer
I got this in Friday, started listening today. These are literally initial impressions, I haven't had time or the energy to start a critical listening session.
- Disappointed by the lack of precision. The Gilmore Lite v2 w/ DPS definitely beats the AE-2 in this aspect. I've been listening to the Gilmore Lite regularly for the past weeks and the AE-2 feels like an instant downgrade. I hope this increases with burn-in.
- All operation is identical with that of the AE-1. The amps are physically identical. The AE-2 uses red LEDs where the AE-1 uses green LEDs.
- I can now confirm that both the RCA and mini jacks act as loop output for each other. Big thanks to Justin, this was a "hidden" feature I love about the AE-1!
- The volume pot is also notched so you can finally tell where the volume level is, unlike the AE-1 where you can't tell at a glance and have to look for the end of the screw hole.
- Bass level is about the same as the AE-1 right now. It's no more emphatic or forceful or deep (I'm using the AD2000 to gauge this).
- Treble energy is weaker than the rest of the frequency spectrum. Sounds as if the treble is being rolled off, around the 14-16 kHz range. Attack is slightly slow as well, I'm not getting the impression the amp is really on the ball with keeping time.
- Control over dynamics isn't as tight as on the Gilmore Lite v2. Sounds like it's quelling too much on loud bursts.
- Ultra-low bass lines are recessed, similar in line with the other battery-powered portables I've heard. Doesn't sound like it's digging deep.
- Signal crosstalk and soundstage are a step up from any portable I've heard so far. Stereo separation is top-notch - sounds in the left and right channels are cleanly placed and very positional sounding. It also has some of the airiness and width of the AE-1, but not quite as much, it's a bit smaller.
- Layer separation isn't up to par. It congests & muddies up with multiple concurrent layers going. It also has a hard time separating the lower and mid frequencies so they kinda turn into a blob.
Burn-in updates below!
Pics:
I got this in Friday, started listening today. These are literally initial impressions, I haven't had time or the energy to start a critical listening session.
- Disappointed by the lack of precision. The Gilmore Lite v2 w/ DPS definitely beats the AE-2 in this aspect. I've been listening to the Gilmore Lite regularly for the past weeks and the AE-2 feels like an instant downgrade. I hope this increases with burn-in.
- All operation is identical with that of the AE-1. The amps are physically identical. The AE-2 uses red LEDs where the AE-1 uses green LEDs.
- I can now confirm that both the RCA and mini jacks act as loop output for each other. Big thanks to Justin, this was a "hidden" feature I love about the AE-1!
- The volume pot is also notched so you can finally tell where the volume level is, unlike the AE-1 where you can't tell at a glance and have to look for the end of the screw hole.
- Bass level is about the same as the AE-1 right now. It's no more emphatic or forceful or deep (I'm using the AD2000 to gauge this).
- Treble energy is weaker than the rest of the frequency spectrum. Sounds as if the treble is being rolled off, around the 14-16 kHz range. Attack is slightly slow as well, I'm not getting the impression the amp is really on the ball with keeping time.
- Control over dynamics isn't as tight as on the Gilmore Lite v2. Sounds like it's quelling too much on loud bursts.
- Ultra-low bass lines are recessed, similar in line with the other battery-powered portables I've heard. Doesn't sound like it's digging deep.
- Signal crosstalk and soundstage are a step up from any portable I've heard so far. Stereo separation is top-notch - sounds in the left and right channels are cleanly placed and very positional sounding. It also has some of the airiness and width of the AE-1, but not quite as much, it's a bit smaller.
- Layer separation isn't up to par. It congests & muddies up with multiple concurrent layers going. It also has a hard time separating the lower and mid frequencies so they kinda turn into a blob.
Burn-in updates below!
Pics:
![ae2_x1.jpg](http://i55.photobucket.com/albums/g156/Asrale/Head-Fi/Portables/ae2_x1.jpg)
![ae2_x2.jpg](http://i55.photobucket.com/albums/g156/Asrale/Head-Fi/Portables/ae2_x2.jpg)