TrollDragon
Headphoneus Supremus
Quote:
Yes... that sir, is an Excellent idea! I'll look into that after the holidays for sure.
Sans plug of course...
But how would one solder the new wire onto the iron if I have only one iron...
Quote:
That is an amazing tip!
Never would have thought of that, I'll try that for sure on my next end installation.
*Note to Self*
Pick up T-Tape
Pick up new Hakko to recable Weller.
Hey man, this gallery is all about building your own cables. I'd say that iron's a prime candidate for a high-end OCC copper recabling in a litz braid with silver solder and gold-plated plugs. Then your every soldering job will be in high fidelity!
Yes... that sir, is an Excellent idea! I'll look into that after the holidays for sure.
But how would one solder the new wire onto the iron if I have only one iron...
Quote:
After soldering a plug, wrap the tape through the exposed joints before putting the housing on. It's usually a better fit than the thick plastic sleeve that plugs come with, and helps minimize the risk of shorts if any of the solder tabs flex..
That is an amazing tip!
Never would have thought of that, I'll try that for sure on my next end installation.
*Note to Self*
Pick up T-Tape
Pick up new Hakko to recable Weller.