Sir Phaded
New Head-Fier
Appreciate it, I just bought the multimeter, probably best to do it right versus guessing and being in a rush haha.
I'll wait to see if anyone has confirmation on the blue/red/copper wires not in the black sleeve.
Thanks
EDIT: So i'm planning on just snipping the wires and not unsoldering them from the driver.
Does this sound right:
Left Blue wire = Tip on 3.5mm Panel
Left Red wire = ring on 3.5mm Panel
Right Copper wire = Sleeve on 3.5mm Panel
Leave the Red and white middle wires (black casing) attached to the board.
CONFIRMATION:
Blue = Tip
Red = Ring
Copper = Sleeve
Got it soldered on and ready to rock! Thanks Everyone.
I'll wait to see if anyone has confirmation on the blue/red/copper wires not in the black sleeve.
Thanks
EDIT: So i'm planning on just snipping the wires and not unsoldering them from the driver.
Does this sound right:
Left Blue wire = Tip on 3.5mm Panel
Left Red wire = ring on 3.5mm Panel
Right Copper wire = Sleeve on 3.5mm Panel
Leave the Red and white middle wires (black casing) attached to the board.
CONFIRMATION:
Blue = Tip
Red = Ring
Copper = Sleeve
Got it soldered on and ready to rock! Thanks Everyone.
Last edited: