-
-
MThere is a paper on simulating the impedance of the ear canal and a remark about how people tend to find such simulation to be tilted...
-
Mmei09891 replied to the thread Smyth Research Realiser A16.Yes, but this might only be achieve by CT or MRI, as far as I know, to accurately depict the structure of ear canals which other type of...
-
MFrom the manual... Immediately after connection, the LED on the head-top will momentarily turn RED while it checks the validity of the...
-
Mmei09891 replied to the thread Smyth Research Realiser A16.1. Recently my head tracker(HT) did not start working vertical sensing except horizontal right after A16 boot up as usual (previously...
-
MGlad you were able to resolve the clipping issue. That setting may be fine because according to Sony it only applies to the optical...
-
Mmei09891 replied to the thread Smyth Research Realiser A16.Many thanks to @gimlet @dsperber @VandyMan and @sander99 This is the way I connect these device: 1. PS5 connected to Sony Bravia. 2...
-
MHave you adjusted the "Max HP Volume" in "Audio Settings", as shown on page 37 of the user manual? I've increased my own "Max HP...
-
MThis does not sound right. Setting the TV volume to max may well trigger clipping. If you are not using ARC, you should be going PS5 ->...
-
MAs VandyMan said, unrelated to the problem. The automatic volume lowering is triggered by digital clipping and has no relation to this...
-
MThat is correct. Yes. @mei09891: I also recommend to switch the automatic volume limiter on again, and never switch it off.
-
MRecommend that you move the gain switch before turning on your A16 - otherwise you may get unpleasant noise in your headphones.
-
Mmei09891 replied to the thread Smyth Research Realiser A16.Appreciate! I will try to increase the gain later tonight.
-
Mmei09891 replied to the thread Smyth Research Realiser A16.Thank you both! I'm using HD800s with gain setting to low. Sony TV volume output set to maximum with standard dynamic range. Through...
-
MAre your headphones plugged directly into the A16? If so, do you have it set to High Gain?
-
MThe best advice I have seen is to use a standalone headphone amp with a digital feed from the Smyth. That way you aren't constrained by...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…