Listing ID:
49815
Views:
3123
For Sale
2,800.00 USD
- Condition
- Excellent/Like new
- Negotiability
- Or best offer
- Ships to
- United States of America
I haven't been using this amp, so I'd rather sell it to someone who can make better use of it.
This was built by user @Dukei, I am the original owner and have had it since May of 2022. No cosmetic or sound issues and it still looks brand new. Paypal and shipping is included.
The amp sounds neutral and is very powerful as it was used mostly for hard to drive planars. You can also connect a tube amp as a pre amp to the cfa3 if you wanna change its sound beside changing the dac for a different flavor.
Final spec of the amp/PSU:
- TKD 10K quad attenuator
- Matched octet of low noise JFET transistors for input.
- Matched small-signal transistors throughout the build
- Golden Reference +/-30V power supply and Nichicon muse capacitors, throughout the build.
- Low noise transformer 150VA. Shielded. 115V AC.
- Headphone Protector/Delay board
- Double shielded OFC wire (for signal)
- 5W non-inductive output resistors
- XLR input, RCA input
- 4-pin XLR/6,35mm output jack
- Low gain/high gain switch
- 1m long umbilical cord
- Blue power switch/LED
I will put the rubber feet for the amp in a seperate plastic bag so it doesn't get lost and I'll also include a power cord.
This was built by user @Dukei, I am the original owner and have had it since May of 2022. No cosmetic or sound issues and it still looks brand new. Paypal and shipping is included.
The amp sounds neutral and is very powerful as it was used mostly for hard to drive planars. You can also connect a tube amp as a pre amp to the cfa3 if you wanna change its sound beside changing the dac for a different flavor.
Final spec of the amp/PSU:
- TKD 10K quad attenuator
- Matched octet of low noise JFET transistors for input.
- Matched small-signal transistors throughout the build
- Golden Reference +/-30V power supply and Nichicon muse capacitors, throughout the build.
- Low noise transformer 150VA. Shielded. 115V AC.
- Headphone Protector/Delay board
- Double shielded OFC wire (for signal)
- 5W non-inductive output resistors
- XLR input, RCA input
- 4-pin XLR/6,35mm output jack
- Low gain/high gain switch
- 1m long umbilical cord
- Blue power switch/LED
I will put the rubber feet for the amp in a seperate plastic bag so it doesn't get lost and I'll also include a power cord.
Listed by:
omega1990 (35)
Listed:
2023-06-24
Last edited:
2024-04-23