Head-Fi.org › Forums › Equipment Forums › Portable Headphone Amps › Analog Squared Paper Discussion Thread.
New Posts  All Forums:Forum Nav:

Analog Squared Paper Discussion Thread. - Page 243

post #3631 of 3640
f111 as in Fitear 111?


forgot about that little guy....hahahah.....gonna dig it out and listen to it next week......

how about the 'not so good'?
post #3632 of 3640
Quote:
Originally Posted by muah View Post

f111 as in Fitear 111?


forgot about that little guy....hahahah.....gonna dig it out and listen to it next week......

how about the 'not so good'?

Listen first than I will report my issues later. This way we can reduce bias.
post #3633 of 3640
Quote:
Originally Posted by AnakChan View Post
 

 

SCORE!!!!

Almost 2 years, I've finally managed to get a partner for my Fujitsu Ten 1T4SF. Won a bid in Yahoo Auction just a few minutes ago. It's 2nd hand used and fingers crossed that it'll work fine when it gets shipped to me later this week. It'll be a miracle if they're matched however at least I finally get a 2nd Fujitsu Ten 1T4SF.

 

Waohhhhh!!!!!  Congratulations!!!!   I wish I can find a pair someday... 

post #3634 of 3640

Hi everybody! sorry if this has been treated previously: I woud like to know if the TU-05 is a good match for 40 ohms IEM? (EarSonics Velvet).

 

- chris

post #3635 of 3640
Quote:
Originally Posted by KrissBill View Post
 

Hi everybody! sorry if this has been treated previously: I woud like to know if the TU-05 is a good match for 40 ohms IEM? (EarSonics Velvet).

 

- chris

 

I use UERM (35 ohm) with TU05 (Low Impedance setting) and AK240. I usually set the TU05 volume knob at around 9 o clock, and use the AK240 for volume adjustment. I prefer using the AK240 volume knob because it allows for much finer control compared to that on the amp.   

post #3636 of 3640

Thank you Daveyston! order for a TU-05 is sent. What about the power? 40mW+40mW is not very much.

 

I will associate a detailed and neutral DAC like a Senoressence Herus. Such a marriage should give very good results. The USB cable is a Totaldac D1.


Edited by KrissBill - 6/27/15 at 2:50am
post #3637 of 3640
Quote:
Originally Posted by KrissBill View Post
 

Thank you Daveyston! order for a TU-05 is sent. What about the power? 40mW+40mW is not very much.

 

I will associate a detailed and neutral DAC like a Senoressence Herus. Such a marriage should give very good results. The USB cable is a Totaldac D1.

 

No prob KrissBill. Congrats on your order!! 

 

Not sure of the power. I've only used TU05 to drive UERM and Oppo PM1 so far, and not surprisingly, it was able to drive these 2 cans with ease. Haven't had a chance to use higher to drive cans with it so far. Sorry.   

post #3638 of 3640

It should be fine then: UERM sensitivity is 112dB/mW while my EarSonics Velvet give 116dB/mW.

post #3639 of 3640

Does using the TU-05 horizontaly increase the microphonic effects?

 

(TU-05 is expected for October)

post #3640 of 3640
I have not noticed a difference between horizontal or vertical but I do hear a small and improved difference in using some isolation under the amp. I also prefer to listen with one tube plate in place. With both in place I find the sound shrinks a little in scale but you get better protection from electrical interference.

With both plates removed the sound is more open but if you have sensitive tubes they can pick up more electrical detritus.

Having one plate seems to my ears at least give the best of all worlds.

As for isolation made up some feet from cork and bluetac which works wonderfully.

Also, make sure you use a good quality ( though it does not hav veto be expensive, the best I have used so far is audio quest green) interconnect.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Portable Headphone Amps
Head-Fi.org › Forums › Equipment Forums › Portable Headphone Amps › Analog Squared Paper Discussion Thread.