DIY estats Left: fr4 stators 110mmx75mm active area, 3 micron mylar, .6mm fr4 spacers, attached wires. Right: wire mesh stators w/ 3d printed support rings, 88mm circular active area, 3 micron mylar, .5mm fr4 spacers, 3.5mm detachable wires (mistake should've done mini xlr, touching the bias...

They were sheepskin replacement pads for koss esp950/a250 on aliexpress. My pair were specifically from 'jingzhi earmuffs official store.' 130mm tall x 95mm wide.

Working on a pair of wire mesh stators soon, I found plenty of extremely fine stainless steel mesh on amazon. I think the stuff I bought is 150micron thick. It's conductive... why would electroplate be needed?

Hey all, it's been a minute since I posted an update. I was making some new diaphragms as I had some issues with my last set, so I figured I would post some pics of my setup. Some lessons learned. The antistatic gel cleanser I was mixing with car spray was no good. First set of diaphragms was a...

Currently no, premium very high is 320 kbps OGG vorbis codec

Not sure what size you are planning for your diaphragm width/active area width but the 6xx chassis is only 84mm wide on the outside. Space inside the cup might be at a premium, you can see how my drivers barely fit inside my cup and my cup width is 105mm with an active area width of 75mm. I...

I cnc'd my own with a cheap 3018 pro CNC router. Took a few tries to get right. Hole diameter is 2mm, spacing is 3mm center to center so 1mm of material inbetween, also done in a 60 degree pattern for maximum open area.

You're in luck. I was just taking them a part to try and figure out the squeal.

Hello chinsettawong and friends, Thank you so much for creating and contributing to this thread. This thread has inspired me to make my own diy estats and am extremely pleased with the results. Build: 1.2mm stators, .6mm spacers. 110x75 active area. Drivers are angled 8 degrees inside the...