tonybuild's latest activity
-
tonybuild replied to the thread Home-Made IEMs.Do you think I should wire them separately? Also,should I always run caps with positive? Because on the graph 📈 I don’t see difference... -
Lose the center tap - connect normally - this will give you more mids as your crossover will move an octave down. 2389 is already very...
-
tonybuild replied to the thread Home-Made IEMs.yeah, i noticed that even when you cut 2 mm off, it shows big difference.
-
tonybuild replied to the thread Home-Made IEMs.I’ve changed it. I just ran negative terminals separately with cap . Middle stays the same. Also, i do feel i need lil more mid...
-
12mm @3mmOD. You can use a series resistor before the cap to lower volume of each 2389 driver in the 2389D config. 5-10ohms usually helps.
-
tonybuild replied to the thread Home-Made IEMs.O interesting:) 12 mm tube or 14 mm ? I tried 14 mm , and its seem to working. Lil bit loud
-
Id wire each C separately with the center wired in line.
-
tonybuild replied to the thread Home-Made IEMs.Hi guys , i just got some sonion 2389d . I think it should be wired like that right? :)
-
-
I'm still new at this but I've tried glueing drivers in the Shell with uv resin which for now hold fine, I use a small syringe to place...
-
tonybuild replied to the thread Home-Made IEMs.Wow. Thank you guys. Its helpful
-
Personally I use Fix and Flash from bostik. It is green until it has been UV cured, then it becomes transparent.
-
SM Ceramic capacitors donot require polarity.
-
tonybuild replied to the thread Home-Made IEMs.Hi guys, what is the best glue for gluing drivers to the wall inside the shell? I made ciem for my friend, and after 6 months, and he...
-
tonybuild replied to the thread Home-Made IEMs.Actually,i just rebuilt the one that got yellow, and look much better and fits great.
-
-
Using the Pro3dure curing unit changed my life. 🤣🤣
