if you use 220v then you need 2A SB 5x20mm. If you ever message Alfred he will guide you to the right fuse as well

go with highend electronics. If you ever blow your fuse they will replace it but to make sure email them and talk to Alfred you need 4A SB 5x20mm assuming you are USA https://highend-electronics.com/products/synergistic-research-purple-quantum-fuses?variant=39439459975286

According to Tim at Kitsune he said the serene is thier best pre followed by the bliss then the preamp in the spring 3

when we say loud what dB we talking? I used my airpods dB level meter and although I really enjoy levels up to 90ish my main is usually around 80ish dB

have a set of caldera suedes used for 4 hrs ..I prefer the thin lamb

very interesteing

i use Grand with headphones and IEMS and they are great for both....I dont notice the weight at all

nice to meet you on FB haha...great write up! can't wait and the itch just got worse!

Standby mode is when you turn it off and the red led shows and lot the green

Burn in is 100% a thing.

I left mine on during burn in process of amp and purple fuse. During this time I turned off the display so there was no led on. Tim also advised to turn off display if you plan on keeping it on 24/7. After burn in process I turn off by pressing the button to leave on standby. Usually takes...

I listen to the MK3 at -30 on the bliss lo-z...curious what you have them at? I run the AC at -15 on the bliss and w/ hqplayer that goes up to -6 because of the -3 limit and -6 PCM GAIN compensation

its like an AC on the go....I'd like to think of it like an AC-Lite. They are different but very similar at the same time if that makes sense. Paired with Cayin RU7 its just right for me. RU7 can power the AC as well but the AC sounds sooo much better on tubes and then the Bliss. I'd be...

AC on high z for sure...low z dulls it out. Because I use the bliss with IEMs as well I have to switch to LO-z for those and sometimes I forget to change to High Z when I swap out to AC and I can tell right away. Curious to what HQ Player filter/modulators you use now? Ive read your review and...

is it possible to use 4.4 and xlr output at the same time to listen to two different headphones? I know it was possible on the topping a90d. I don't want to blow anything up so thought I'd ask here first. Thanks!