Recent content by scottosan
  1. scottosan

    Late to the party, Objective to with some technical observations

    Took some time off for a few years. Previously used an Asus STX and/or Darkvoice 336. I also play guitar and have been building guitar amps and pedals for years, but not til recently decided to build and headphone amp, which lead me to the Objective2. I read alot of reviews, many of which...
  2. scottosan

    Need recommendation for openback cans for Objective2 amp

    1. I'm on a budget ~$200 or less 2. Prefer open back 3. Prefer higher impedance although open if anyone has experience with the objective2 and low impedance) 4. I listed to all sorts of music, female vocal, instrumentals, jazz, rock, etc.. Thanks, Scott
  3. scottosan

    Calling All "Vintage" Integrated/Receiver Owners

    Marantz 2252b with my new Klipsch Forte II speakers https://www.youtube.com/watch?v=VbrzxeXesCY&feature=youtube_gdata_player
  4. scottosan

    Calling All "Vintage" Integrated/Receiver Owners

    I just got my Marantz 2252B back from surgery.  Cosmetically, it looked like it was salvaged from hurricane Katrina.  It had loose knobs and the selector swithc had one side of the knurled shaft missing so that a know wouldn't even stay on. All new electrolytics and speaker relay replaced.  The...
  5. scottosan

    Sub $500 Headphone Amp for T1

    To my knowledge you can only use dolby headphone through the STX headphone out, and NOT the RCA, unless the previous poster knows some non-supported mehod
  6. scottosan

    Calling All "Vintage" Integrated/Receiver Owners

    I've bought a Marantz 2252b and a 2238b within the past week.  Truly a musical line of vintage receivers
  7. scottosan

    Vintage receivers (Pioneer, Luxman, Marantz, Sansui)?

    I just bought a Marantz 2252b for 100 bucks off of craigslist.  10 dollars for some contact cleaner and my high end stuff sound thin compared to this beauty
  8. scottosan

    I2S Input?

    sorry responded to wrong thread
  9. scottosan

    5670 W396a 2C51 6N3P tube thread

    No it will cause damage
  10. scottosan

    sharing worst experience in audio-gd! Be careful everyone..

    How does it sound without eq? Although the dac is doing the decoding, you pc is still altering the tone if you are using the eq.  Are you using USB, or spidf?  My setup disables the eq when using spidf, but usb treats it like a soundcard and eq options are available. It very well could be your...
  11. scottosan

    List of entry level TUBE amps + mod for less than $300

    I would go with the Darkvoice 336se for several reasons over the Little Dot.  The Darkvoice 336se, is mostly point to point wired, which lends itself to easier modding and repair down the road.  Also the tubes used a much easier to come by and much cheaper for NOS tubes.
  12. scottosan

    5670 W396a 2C51 6N3P tube thread

    As far as these variants, I have tried a bunch and this is the one instance were the Chinese 6n3t (taller version) is better than the NOS stuff out there. All of the NOS sound dull and boomy
Back
Top