Ahem, you do know what DC offset is and why it is standard practice to keep it as close to zero as possible - right?

Haven't been here for a while, but is this the state of high-end audio today?? Nearly $14k for something that isn't even built on proper PCBs?? And plywood side panels to disguise that the enclosure is something you can buy for a DIY-project for around $100 from modushop.biz? Equally amazed and...

A little bit at the bottom of the volume range perhaps - what's the approximate position of your volume control when you listen?.   It's not uncommon for small volume pots like those used by Stax for the 252 amplifier to have tracking errors in the lower end of the range. If you can, find a...

Ahh, thanks. Thought some dealer was clearing out their last inventory of the old models at that price    /U.

  Can I ask where?   /U.

  Agree with your comments regarding electrostatics, but remember that "burn-in" (= changes in electrical parameters after initial use) is very real and very measurable for loudspeaker drivers, so it stands to reason that a dynamic headphone transducer could well exhibit the same. HOWEVER, (in...

Related question: Does anyone know how to implement ABX-logic in a microcontroller (like Arduino) which could then control relays for input selection?   /U.

Looks good! Really like that chassis design :-)   /U.

Fixed this for you :D   /U.

http://www.head-fi.org/t/223263/the-stax-thread-new/19785   /U.

Sent you a PM.   /U.

Not really a "build" yet, but it will come. No prizes for guessing what it is going to be though ;)     /U.

I recently had some KGSSHV and PSU boards made (latest onboard version) and have a couple of pairs left over, so PM me if you need a pair.     /U.

If you give up that easily, you may want to find a different hobby straight away...   If not, then first:   - Short the input to ground and measure DC offset on the output - Remove the socketed ICs and measure the supply voltages with respect to ground.   and then post here what you get...

The only function here is reverse polarity protection. The reason for choosing a schottky diode is that it has lower voltage drop, so while a standard diode could be used it might impact your perceived battery life (because lower voltage = risk of signal clipping). /U.