Recent content by Giuss
-
Millett "Starving Student" hybrid amp
Thank you very much to all About the tubes, I found them some time ago on ebay, and I bought 3 pieces of them Bye- Giuss
- Post #4,315
- Forum: DIY (Do-It-Yourself) Discussions
-
Millett "Starving Student" hybrid amp
Do you thin that I can have a better audio quality using this cable instead of the ipod headphone output? Using this cable, I can bypass the ipod internal power amplifier?- Giuss
- Post #4,310
- Forum: DIY (Do-It-Yourself) Discussions
-
Millett "Starving Student" hybrid amp
Hello, this is my starving student, it works great- Giuss
- Post #4,306
- Forum: DIY (Do-It-Yourself) Discussions
-
Millett "Starving Student" hybrid amp
Hello, which temperature do you have on your heatsink? I'm testing a single heatsink for both mosfets, this heatsink is 9x5x2 cm, so is not small, and I have more than 60°C I know that it isn't a dangerous temperature for the mosfet, but I think that it's too high- Giuss
- Post #3,664
- Forum: DIY (Do-It-Yourself) Discussions
-
A Very Compact Hybrid Amp
Quote: Originally Posted by runeight I guess to suggest the obvious, and not necessarily to push the products, but if you were to buy a kit you would get all the necessary components. Ok thanx, but I'm not sure if is convenient to order the kit from Italy for shipping and...- Giuss
- Post #687
- Forum: DIY (Do-It-Yourself) Discussions
-
A Very Compact Hybrid Amp
Where to find constant current diodes? Is possible to use another solution? Like LM334 or discrete solution for constant current? Bye- Giuss
- Post #671
- Forum: DIY (Do-It-Yourself) Discussions
-
A Very Compact Hybrid Amp
Is it possible to see complete schematics?- Giuss
- Post #635
- Forum: DIY (Do-It-Yourself) Discussions
-
A Very Compact Hybrid Amp
Are schematic and project details avaiable?- Giuss
- Post #354
- Forum: DIY (Do-It-Yourself) Discussions
-
Millett "Starving Student" hybrid amp
Quote: Originally Posted by dsavitsk Sounds like a good solution to me. I have my doubts that the 12AX7 will overcome the fet's gate capacitance, and the gain is likely too high, so I think the 12au7 is the better choice here. AT7, AY7, and AV7 are all worth looking into as well...- Giuss
- Post #2,534
- Forum: DIY (Do-It-Yourself) Discussions
-
Millett "Starving Student" hybrid amp
Hello, I've seen that the 19J6 tube is very hard to find, so I've a question Is it possible to use other type of tubes with 12.6v filament like ECC82 or ECC83 ? They need 150ma like the 19J6, so if I add a resistor I can use these filaments with a 19V supply For the original 19J6 : 19V...- Giuss
- Post #2,527
- Forum: DIY (Do-It-Yourself) Discussions