Derrick Swart
Headphoneus Supremus
Western Spaghetti !Good Shiit!
Western Spaghetti !Good Shiit!
Unix v7 -> x86 and yes to Soul of a new Machine!Back in the day - when I worked for the UK's indigenous computer manufacturer - we were banned from using codenames as they invariably crept out to the public and into documentation of all kinds causing confusion at the very least. Though I do remember the Dragon being shot publicly on stage. IIRC, Manual from Faulty Towers was part of that undertaking.
We replaced the Dragon with a machine built around this newfangled thing called SPARC (and for those technical folks amongst you, ported UNIX SVR4 onto SPARC - most folks to this day think Sun did it) and delivered a very successful product. If any of you have read Kidder's 'Soul of a New Machine' he comes closest to capturing what it's like to build a new clean sheet machine in my experience.
Cheers
Unix v7 -> x86 and yes to Soul of a new Machine!
l like tubes so Saga+ works for me, but if I went Freya S then I could go balanced from my Gumby. Maybe Freya+ , but I really don't want to fuss with 4 tubes. ..... Ragnarok 2 so then no IC between pre and Amp..... And round and round my mind goes.
Inter-connect - as in cables. Too many acronyms in this hobby.What is an IC?
.
The Bifrost 2 manual warns not to cover any vent holes. It has no vent holes.
It also says not to put it close to a "heat source". So... no to stacking a Jotunheim on top?
It got quite hot under there, maybe Bifrost 2 could use some vent holes on the sides at least.
Yes, the ability to use Unison with Modi Multibit would have been fantastic. But if Unison won't be offered with MM, it may be a deliberate decision to highlight the differences the higher tier products have with the entry level Multibit DAC.
Once again, this is another example of why Jason wants people to use proper names instead of nicknames or acronyms. In this case, MM stands for Modi Multibit.What is MM?
.
So probably a bad idea to balance it on a Freya's four tubes...
But seriously, I was wondering whether it could be stacked on the uncut side of a Freya+. Sounds like that could be iffy or worse.
Keep line up simple and replace the SYS with SYS S the same plus balanced connections for a bit more, i think that might be a hit, more expensive must be better logic !!!
Inter-connect - as in cables. Too many acronyms in this hobby.
Inter-connect - as in cables. Too many acronyms in this hobby.
I ordered these slightly more reasonably priced cone feet: https://www.amazon.com/gp/aw/d/B07PHM1MTGJust get some of these to go between them so the heat can escape. You'll be fine.
https://highend-electronics.com/products/shun-mook-diamond-resonator-feet?variant=6373109955