Boggo
New Head-Fier
- Joined
- Sep 9, 2012
- Posts
- 1
- Likes
- 0
I have inadvertently ripped the wiring from the circuit board of the volume and balance control of my surround sound headphones The Mic- Mic+ and FR wires remain attached.
I need to solder wires to RL,FL, RR, CEN SUB VCC and GND.
The wires I have available appear to be Blue/Red, Green/Red, Green/Copper, Green, Red, Copper and finally Blue.
I have taken a photograph of the offending item but am not sure if I may post it for fear of upsetting the powers that be.If you think I will not be breaking any rules then I am happy to post the photograph
I have spoken with the manufacturers of the equipment but they seem unwilling or unable to help.
I apologize for joining this forum solely to get something out of it and perhaps not putting anything in but I would be really appreciative if someone can help.
.
I need to solder wires to RL,FL, RR, CEN SUB VCC and GND.
The wires I have available appear to be Blue/Red, Green/Red, Green/Copper, Green, Red, Copper and finally Blue.
I have taken a photograph of the offending item but am not sure if I may post it for fear of upsetting the powers that be.If you think I will not be breaking any rules then I am happy to post the photograph
I have spoken with the manufacturers of the equipment but they seem unwilling or unable to help.
I apologize for joining this forum solely to get something out of it and perhaps not putting anything in but I would be really appreciative if someone can help.
.
