[Neophyte]

Since I'm realy bad @ point to point wireing + I worry about playing with such high voltages. I've been thinking of PCBing a MJ amp and powersupply. I was wondering what people though of it or how hard it would actualy be? I was planing to use express PCB software. I'm guessing that they should have the ability to board mount a tube jack.... THoughts???

 

[eric343]

If you're planning to tuberoll at all, chassis mount the tube sockets as the stress of removing/replacing the tubes will soon wreak havoc on your PCB. At least include PCB mounting holes close to the tube sockets to stabilize the PCB, that will help a lot. (not speaking from experience, just what I've heard.)