chosen1
100+ Head-Fier
- Joined
- May 15, 2003
- Posts
- 146
- Likes
- 0
I finally finished my high-end PPA project.
I had to source parts from 8 different places, and it took about a month to get them all.
Specs:
PPA amp board
STEPS board
Nichicon FG caps in C1 and C4
BC, Pana. FC, and Nichicon caps everywhere else
Vishay-Dale resistors throughout
OPA 627's on all three channels
Uncle Phil's diamond buffer
Cardas GRFA RCA's
Trimmer pots for R8 ala doobooloo
No bass-boost
Neutrik locking jack
Bulgin lighted power switch
All wire in signal path is teflon-insulated solid silver
Par-Metals 20-series case (completely clear-anodized)
Enough of that, here's the prOn:
I mounted the Alps blue off-board to allow the installation of the stepped attenuator I will be recieving soon.
I had to source parts from 8 different places, and it took about a month to get them all.
Specs:
PPA amp board
STEPS board
Nichicon FG caps in C1 and C4
BC, Pana. FC, and Nichicon caps everywhere else
Vishay-Dale resistors throughout
OPA 627's on all three channels
Uncle Phil's diamond buffer
Cardas GRFA RCA's
Trimmer pots for R8 ala doobooloo
No bass-boost
Neutrik locking jack
Bulgin lighted power switch
All wire in signal path is teflon-insulated solid silver
Par-Metals 20-series case (completely clear-anodized)
Enough of that, here's the prOn:
I mounted the Alps blue off-board to allow the installation of the stepped attenuator I will be recieving soon.