[TheC1aw]

Hello, I wanted to mod my M50 to have a detachable cable and microphone.
 
This is how I was thinking to set it up: Two 3 pin/pole 3.5 mm cables into a 4 pin/pole cable that is attached to the headphones, then a removable microphone attached to the headphones too. I want it to work even if i remove the microphone. I will buy a 4 pin to 2 x 3 pin splitter and then remove the 4 pin female connector and attatche an 4 pin male connector. Then i will buy one 3 pin connector for the microphone and use the 4 pin female connector on the headphones.
 
How can I make this work. Thanks in advance

 

[jmegawarne]

Did you make any progress with this project? I was thinking of doing the same.