1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.

    Dismiss Notice

iPhone 6s and using a rsa p-51 possible?

Discussion in 'Portable Headphone Amps' started by cjoh242, May 17, 2018.
  1. cjoh242
    I’m looking to pick up a used p-51 and wondering if the amp would work with the iPhone 6s. Would I connect it through 3.5mm hp jacks? Thanks
  2. RAQemUP
    A 3.5mm to 3.5mm cable from iPhone headphone out to line-in of the P-51 would work. Just keep in mind that way is not the most optimal setup. You would be double amping the signal which may not be the cleanest sound as the iPhone headphone out is not a flat line-out.

    If you do decide to do it though put the phone volume to 85 to 90% max volume to prevent distortion/sound artifacts before controlling the volume through the P-51.

    Double amping can be just fine though as I use to double amp a Cowon D2 to great effect. I also own an RSA P-51 myself and it still is a great little amp.
    Last edited: May 18, 2018
  3. cjoh242
    Dug a little deeper and found the dragonfly red. I’m pretty pleased with it.

Share This Page