Separate names with a comma.
Did you turn off the Bluetooth, Wifi, and the screen is off?
Hello, bluetooth and screen were off. Wifi was on but Keep WLAN on during sleep was set to Only when plugged in. The standby drain is very bad on my device and I already have reset it to factory settings. Should I also disable Wi-Fi?
Thx a lot, I will try the new version later when off work today.
We have reported to the engineer about your feedback. They will try to access the feasibility first.
Would you mind turning off the Wifi and check again?
Ok, I’ll do that and come back with feedback.
The test.aac file you sent is not standard AAC file so the decoding library could not support it currently, sorry.
Does the M11 have a bass boost ? I couldn’t find anything but the EQ
Which port do I use on the M11 to plug the 3.5mm end into.
Really man? There are 3 ports, all with different sizes...
With screen turned upwards, from the left: 4,4mm / 2,5mm / 3,5mm.
I realized this after I looked at the manual. Sorry for the question.
No need to sorry There is only one place when you can fit without loose 3,5 jack
I've just got my M11, but can't get any sound. I'm using the 3.5mm output and in the audio settings, it's set to PO. Any ideas?
Edit: The 2.5mm output works fine. No way to test the 4.4mm.
Suggest you check whatever is on the other (non-M11) end of the 3.5mm cable. Maybe you just need to turn up the volume on that end, or enable input channel selection on the receiving device.
I've tried other IEM's on the 3.5mm and nothing working. It's not connected to an amp or anything . Just using as a standard DAP.