Do DIY headphone cables need to be braided?
Dec 31, 2012 at 8:44 AM Thread Starter Post #1 of 5

rdaneel

100+ Head-Fier
Joined
Apr 1, 2008
Posts
293
Likes
105
Hi,

I'm a long time lurker considering my options for a longer cable for the HiFi man HE-400s I have my eye on. I'm trying to get a 20 foot cable for less than the cans cost, which is surprisingly tough!

The DIY route is appealing, I can buy the via blue connectors, sleeving, etc. very easily, but the braiding and soldering are a but daunting. I have no experience whatsoever soldering.

Using an insulated cable, like Miami is a lot less intimidating, but it seems like every DIY project uses a braided geometry. Is that necessary for noise rejection, or is it a cosmetic preference?

Thanks for any thoughts!
RDaneel
 
Dec 31, 2012 at 10:48 AM Post #2 of 5

mchang

500+ Head-Fier
Joined
Jan 21, 2004
Posts
708
Likes
21
If you use the Mogami as-is (with its rubber sheathing on), it will be more than properly shielded. Under the sheathing is a layer of wiring that is there to provide shielding. And beneath that, the individual wires are twisted, which purports to cut down on interference as well.
 
Translation: You don't have to braid, although it is easy once you get a system/rig set up. But you will need to learn to solder. Look online for videos and get practicing before you attempt on your headphones.
 
I've recabled headphones and built cables with Mogami as-is and I've braided individual strands for aesthetics as well. All sound great.
 
Jan 1, 2013 at 2:28 AM Post #4 of 5

KimLaroux

1000+ Head-Fier
Joined
Aug 2, 2011
Posts
1,090
Likes
69
Headphones are low impedance, which means they are essentially immune to electro-magnetic interference. And unless you have a balanced amplifier and a balanced cable with your he-400, you're using a 3-wire cable where one of the wire is essentially grounded. This creates an asymmetrical connection where there is no common-mode rejection. Only balanced cables, connected to properly designed balanced gear, have common-mode rejection
 
Shielding an headphone cable is probably overkill if you're gonna use them at home. Though there are environments where the shield of a 3-wire cable, connected to ground, does help. The reasons why star quad cables are shielded is because (1) they were designed for microphones and interconnect, which have high impedance inputs and (2) they are meant to be used on stages and studios saturated with EMI. The shield is not needed for headphones. In fact, many people who used those cables for headphones simply removed the sheath and the shield, and used only the twisted quad.
 
Twisting wires together is more effective than braiding. All manufactured balanced audio cables are twisted wires. Braiding is just a pretty alternative invented by DIY'ers to build their own cables. It's a bit more convenient if you're not gonna sheath the cable. It allows for a looser braid, which is more flexible, without breaking apart.
 
Jan 2, 2013 at 5:23 PM Post #5 of 5

dadong

Head-Fier
Joined
Nov 15, 2010
Posts
87
Likes
11
Braiding is mostly for aesthetics and to remove mechanical noise from the wires bumping into each other. If you're going for the best bang for the buck, just get mogami or canare starquad which costs about a dollar per foot. Though I don't really like to use those cables for headphones since they weigh too much and doesn't have the wow factor of a custom made cable. 
 

Users who are viewing this thread

Top