1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.

    Dismiss Notice

Conisdering modding my RoCoo P

Discussion in 'Portable Source Gear' started by frapiscide, Aug 20, 2012.
  1. Frapiscide
    I've had this idea to remove the soft plastic front and back of the RoCoo P and make a new front and back out of 6Al4V titanium.  I'd also get some lexan and cut it out in order to fit over the screen.  Has anyone taken the front and back off of their RoCoo P?  I'm assuming that they glued the front and back onto an aluminum chassis.
     
  2. ClieOS Contributor
    I have seen picture of the front and back plastic cover being removed. Yes, they are glued on and will likely break when you pulling them apart.
     

Share This Page