Separate names with a comma.
Yes it is!
Aha - I have cycling colours!
I’m happy to report mine has successfully updated. Nothing major to report here, seems much the same as before, but we shall see what it’s like over the course of the next week or so. I don’t subscribe to either Tidal not Quobuz so those options don’t benefit me, unfortunately.
The update went smoothly, just not enough information present to confirm what was going on, which is expected when your UI consists of two LEDs.
Nice work guys in any event. I’m hoping this release fixes everyone’s Poly and they can enjoy their devices.
It's done, 2.0 alive and kicking.
However, can I get it as a download file so that I can flash it over usb next time, as your update process scares me.
Mine has updated to 1.0.41 but the Update Firmware button hasn't appeared in GoFigure App.
Have you updated GoFigure?
To anyone with slow updating just to clarify a couple of things.
1. Your Poly must be connected to a charger and on charge.
2. The micro SD card should be removed before you switch on otherwise the update cannot install.
They've resisted allowing downloadable updates for some reason. I agree, I don't like the obfuscation either!
Just double check you have the latest Gofigure app installed. The firmware button does not appear on the older version of the app. Also have you power cycled after installing V1.0.41?
No I'm afraid not. The micro USB is for charging only and updating via the micro USB is not possible.
Copy that - was careful about both.
90 minutes later and still going red...green....blue...
Took me almost an hour to get the .41, but the 2.0 update completed in less than 5 minutes!
Also, I had to do that as well!
@Matt Bartlett - how long should I leave it updating (currently 100 minutes)? If necessary is there a way of rolling back and updating again - factory reset and update - or something else?
Yes, I think so.
I'm just talking with the software guys and will get back to you asap. I'll PM you back as soon as I can.