Can a STEPS PSU take 120 and 220?

[grandenigma1]

I am selling my PPA with STEPS and I was asked if it could take 220v. Anyone who is more knowledgeable about this have any ideas?

Thanks!

 

[Erik S.]

From Tangent's site

Quote:

The A through D pads configure the transformer's primary side for your country's wall voltage: 100-120V power: Put a short jumper from the A pad to the B pad on the board. Jumper the C pad to the D pad. 220-240V power: Put a short jumper from the B pad to the D pad on the board.

EDIT: Step no. 3 on http://tangentsoft.net/elec/teps/steps.html

Hope this helps

 

[grandenigma1]

dont know how I missed that! Thanks a lot!