- Joined
- Jan 30, 2011
- Posts
- 13,315
- Likes
- 24,354
I love the preformed wire (fwiw)
Does the shure goam tips fit on the new desing?I'm right there with you @Brooko.
Forgot to post pics of the revised nozzle on the B400. The revision is a big plus imo because it allows a greater variety of tips to be used and addresses my concerns about potential fragility of the old nozzle design. New one is much beefier. I haven't noticed any affect on sound, then again I haven't a/b'ed the two yet.
Does the shure goam tips fit on the new desing?
Forgot to post pics of the revised nozzle on the B400. The revision is a big plus imo because it allows a greater variety of tips to be used and addresses my concerns about potential fragility of the old nozzle design.
Would you please share the measurements for the reworked nozzle? I've ordered the B400 during the pre-order phase for the next batch so I assume I'll receive that one. I'm intending to use them with Spinfit CP800 and Twinblade - can anyone confirm compatibility with the revised nozzle?
Would you please share the measurements for the reworked nozzle? I've ordered the B400 during the pre-order phase for the next batch so I assume I'll receive that one. I'm intending to use them with Spinfit CP800 and Twinblade - can anyone confirm compatibility with the revised nozzle?
Ok, thanks. It doesnt help me. Whats the old size? Thats on milimetres? Are you going to change the provided tips nozzle size?Hello JetPistol,
Here is a drawing of the new B400 nozzle with it’s dimensions. I hope this helps.
Ok, thanks. It doesnt help me. Whats the old size? Thats on milimetres? Are you going to change the provided tips nozzle size?
Reading others answers, im asuming that the shures wont fit on the new desing, so....
Ok. Thanks. That help a lot. So now the oudside diameter is the same as the previous one, but the inside diameter is the same than the oudside diameter that gives stronger structural capability to the nozzle.Nothing actually changed to the diameter, there just used to be a indent, which was removed and filled, giving the nozzle a uniform diameter. A ridge was added so that tips wouldn't slip off (this is what the previous indent helped to do).
Nothing was changed to the tips provided and tip compatibility is the same as was with the previous nozzle design.
I'm just using a tape measure so someone else will need to provide more accurate measurements, but it's ~4mm average with that small flare extending out to just below 5mm.
Hello JetPistol,Here is a drawing of the new B400 nozzle with it’s dimensions. I hope this helps.
Thank you very much for the quick responses! Are there any recommendations for silicone tips other than the Spinfit CP800? Speaking of foam tips, I already own INAIRS Air 2 which should fit the B400 nozzle.