fordgtlover
Headphoneus Supremus
I am starting the planning for my ß22. It occurred to me that one of the biggest challenges will be neatly arranging the power and signal wiring across the three boards. I know that the e22 backplane was designed to address this issue, but these are no longer available. I was curious whether there would be value in little distibution boards.
I am considering this as an option for mine but I would rather have a commercial one rather than a hand etched.
Does this sound sensible?
I am a newbie to electronics, and have never designed a board. If this is a sensible idea I guess the starting point would be to design something in Eagle and post for review and comments.
How does this sound, and would other ß22 builders be interested (read could I sell some if I had a few extras made)?
cheers
I am considering this as an option for mine but I would rather have a commercial one rather than a hand etched.
Does this sound sensible?
I am a newbie to electronics, and have never designed a board. If this is a sensible idea I guess the starting point would be to design something in Eagle and post for review and comments.
How does this sound, and would other ß22 builders be interested (read could I sell some if I had a few extras made)?
cheers
