the1andonly
500+ Head-Fier
So a lot of people got this, I found some tricks using it and discovered I was going some things wrong so I guess this thread is to make them known, for anyone else to post tips or tricks, and if anyone wants to talk about the sound.
1. Connecting to PC
Apparently this just werks for some, for others it didn't, for me it didn't but I was able to connect.
I had to
1.make sure it was "forgotten" or "unpaired" (not just unconnected, fully unpaired) with any other device, for me this was my phone.
2.Then I had to initiate connection while still in case, which is to close case when them in it for a few seconds, reopen, and do whatever the touch controls are to connect, IIRC it was left side double tap or hold down or combo of those, it's in the instructions.
3. middle light would start blinking fairly rapidly
4. find the Left side on pc searching for bluetooth, make sure the icon next to it is headphone and not anything else
5. connect left side, shortly after a prompt automatically comes up that the right side wants to connect,
6. accept prompt
Also to note, I had trouble doing this again later but didn't really try hard as I plan to use it with my phone only, that might change because of a fix I found below.
kinda not a fix because the instructions say to do this but the implementation is bad IMO
So it has an EQ setting, I thought this was light to maximum, it is not, like instructions say, you need to play around, at either end it was pretty bad, with my current setting
It is actually pretty good, and for sure much better... Decent now for standing right by the shower on and much better next to my AC unit, I hardly hear it now where before it was pretty clear, can still hear myself typing pretty loud, but play around with it and find what you like.
1. Connecting to PC
Apparently this just werks for some, for others it didn't, for me it didn't but I was able to connect.
I had to
1.make sure it was "forgotten" or "unpaired" (not just unconnected, fully unpaired) with any other device, for me this was my phone.
2.Then I had to initiate connection while still in case, which is to close case when them in it for a few seconds, reopen, and do whatever the touch controls are to connect, IIRC it was left side double tap or hold down or combo of those, it's in the instructions.
3. middle light would start blinking fairly rapidly
4. find the Left side on pc searching for bluetooth, make sure the icon next to it is headphone and not anything else
5. connect left side, shortly after a prompt automatically comes up that the right side wants to connect,
6. accept prompt
Also to note, I had trouble doing this again later but didn't really try hard as I plan to use it with my phone only, that might change because of a fix I found below.
kinda not a fix because the instructions say to do this but the implementation is bad IMO
So it has an EQ setting, I thought this was light to maximum, it is not, like instructions say, you need to play around, at either end it was pretty bad, with my current setting
It is actually pretty good, and for sure much better... Decent now for standing right by the shower on and much better next to my AC unit, I hardly hear it now where before it was pretty clear, can still hear myself typing pretty loud, but play around with it and find what you like.
