I agree, ordered battery for mojo here https://www.thecableco.com/chord-mojo-replacement-battery.html and just touched up solder on both 3.5 ports while it was open.

I like the stand, must have just come out. Been using a piece of patagonian rosewood (not a real rosewood) as a stand, it has more mass than the Qutest and I think its makes a difference.

Thank you, swapping them out for the 25's then!

Just to be clear, will the 16v Silmic be ok with the upgraded power supply or do we need to go 25v?

Pre-ordered! Also ordered a Qutest, silly summer fun!

I would get the usb option as I could use it for my mojo/poly setup! Been using the MoPo with the GL2 for over a year powering HD6xx, Ety ER4SR, iSine 10s and as a pre for ADAM A3X. GL2 made the MoPo faster with the transients, bolder with the bass, added detailing to the mids and highs...

I did almost the exact same processand it finally worked kicking it into V2.0. Glad I didnt have to do the blood sacrafice I was planning on...

I tried a factory reset and after all the hoop jumping, it still goes into update mode with the endless color cycling

Yes, the colors keep cycling upon each reboot. Going to fully charge the Poly and try again.

I get to the point to where 'the voice' inside my Poly tells me that the software update is pending and I should reboot the poly. Afterwhich it will take 10 minutes to update Poly. I reboot and then 'the voice' tells me once again, to reboot to start the update. 4 times now. Also glad I...

I tried powers cycling it twice now and it just started the color cycling again.

According to my router, my Poly pulled 190MB from your server then stalled. It is still just cycling through colors now.

and done

@Matt Bartlett - Same here, cycling colors for over 80 minutes. Any info on upgrade reset would be appreciated.

Firmware update in progress 45 minutes. blue, red, green, blue, red, green...

1)  71, 908 2)  76, 809 3)  79,601

1) 146,789 2) 168,567 3) 188,987

Here are my results.  Powering them with a Lyr and loving it!    After 2 weeks the headphones have not exhibited any harsh highs and the bass is definitely not anemic.  Just the right amount of warmth and a whole lot of detail.  

It may have something to do with my SE cable being the stock cable and the BE is the Moon Audio cable, not sure.  Could also be that I'm turning it up more since I fell it sounds better.

I went with balanced Moon Audio Silver Dragons for a pair of Noble Savant UIEMs being fed by my 100ii.  The biggest things I noticed were the sound stage was wider and the bass seemed to have better extension and a little more punchiness to the transient.  The highs seemed to get a smidgen more...

109,864 105,477 102,890

But you need to use the AK Connect button on the AK100ii, there is no longer the MSQ button located on the home screen.

Sorry, MSQ has been replaced on the AK100ii FW itself, not on the host PC/server.  As for the EQ it seems the ability to draw them in has been removed, you can select 1 of 10 bands and increase/decrease them by.5 db.

The FW also removed the decimal points thus the higher volume number.

Interface is a little cleaner with a better emphasis on whats playing.  MSQ has now been replaced with AK connect which does a better job of streaming and allows control of my AK100ii from android phone.  As for sound, I want to say that their is a slight increase in instrument separation as...