Search results for query: *
- Users: dcrane
- Content: Threads
- Order by date
-
Sony MDR-CD3000 repair
I need to get my headphones repaired. They are the CD3000 and are a bit old. The cable has become loose causing the sound to go in and out. Also, the ear pads are disintegrating. I don't know if there are any more ear pads around. These cans have been discontinued. Will Sony be able to fix...- dcrane
- Thread
- headphones over-ear sony-mdr-cd3000
- Replies: 11
- Forum: Headphones (full-size)
-
1st PIMETA - high pitch buzz
I just finished my 1st PIMETA and it sounds good except under certain circumstances. After I connect my DAP(iAudio x5L) for a while, I hear a high pitched buzz. It takes about 5 sec and goes away turning it off then on again. However, this does not happen when I connect it to my cdp (Rotel). Any...- dcrane
- Thread
- Replies: 19
- Forum: DIY (Do-It-Yourself) Discussions
-
finding a local electronic parts store
I am short a couple of cheap resistors in my current project [pimeta]. But, the only local store that I know that has parts is Radio Shack. They are ok but they have a limited selection and seem way overpriced. Does anyone know how I can find a local store that sells small parts? I live in...- dcrane
- Thread
- Replies: 7
- Forum: DIY (Do-It-Yourself) Discussions
-
Where to buy circuit boards
Is there anywhere else I can buy printed circuit boards individually other than from Tangent. I'm want to find other projects are available that won't require a breadboard or making my own circuit board. I saw expressPCB which you can buy 3 for $51 but wanted more projects similar to the ones...- dcrane
- Thread
- Replies: 6
- Forum: DIY (Do-It-Yourself) Discussions
-
Defluxer/cleaner recommendation
I am going to order some stuff I need and want to get something to clean my work. I've never used anything before - I just leave it on there. But I've had to fix some commercial electronics (receiver, dvd) and the stickiness annoys me. So, which stuff do you guys recommend? I use Cardas quad...- dcrane
- Thread
- Replies: 12
- Forum: DIY (Do-It-Yourself) Discussions
-
need better armband for U2
I am looking for a smaller armband for the U2. Has anyone found anything better than iAudio's armband. Their's seems a little big for the player...and stiff.- dcrane
- Thread
- Replies: 0
- Forum: Portable Source Gear
-
Does Zen Touch have line-out?
Title says it all.- dcrane
- Thread
- Replies: 1
- Forum: Portable Source Gear
-
looking for 40GB audio player
My karma is dying and I might have to get another player. It's completely filled and I would like something bigger. Most of it is flac. I want a player that supports mp3 and a lossless compression. Audio quality is very important. Ogg is good and sounds better than mp3 but not as good as...- dcrane
- Thread
- Replies: 8
- Forum: Portable Source Gear
-
TEPS Problem - low output voltage
I'm getting around 7.5 volts output voltage. I am using 1.82K ohm for R4 and 120 ohm for R3 with the standard vset. Adjusting the vset has no affect on the output voltage. I already checked to see if I put R3 and R4 in the right spots. Any ideas what is causing this?- dcrane
- Thread
- Replies: 7
- Forum: DIY (Do-It-Yourself) Discussions
-
gmail invitations
I have 6 invitations. PM me if u want one. PS I need to send it to a valid email address- dcrane
- Thread
- Replies: 9
- Forum: Members' Lounge (General Discussion)
-
Opamp rolling PPA - Which way to put in
I purchased 3 AD8610 opamps on browndog adapters for my PPA and am trying to figure out how to put them in - which way is "up". Does it matter? If so, what is the correct orientation?- dcrane
- Thread
- Replies: 6
- Forum: DIY (Do-It-Yourself) Discussions
-
Banana Plugs - looking for 8 plugs <= $35
I've been poking around this forum trying to figure out which banana plugs to get for a set of speaker cables that I will make. These connections will be soldered. Also, I am considering using Canare 4s11 for the wire. It's 4 conductor, 14AWG per conductor at about 70 cents a foot. Here are some...- dcrane
- Thread
- Replies: 0
- Forum: DIY (Do-It-Yourself) Discussions