Search results
  1. diforce

    Darkvoice 336i & 336SE Tuberolling PartII

    The hum on the left channel with the red base Tung Sol preamp tube didn't disappear on my amp :L3000: had to be more than 100 hours by now... anyway Are the double straight black solid core wires that go into the tube sockets are the heater wires ? (Post #2149) I was told i should replace them...
  2. diforce

    Darkvoice 336i & 336SE Tuberolling PartII

    Actually it only recently went away, I had it running non stop for 48 hours and still nothing, and then another week or so of 10 hours per use daily. only now it's barely noticeable but I can still hear it. Gonna do the 220uF cap mod regardless. I can still hear it.
  3. diforce

    Darkvoice 336i & 336SE Tuberolling PartII

    I have the red base one but it says 1810 and not 1803, anyway much better than the original, "S" is less knivy in your ears but still sharp, but my tube have a terrible left channel noise, was told to leave it on for 72h but it's on and off for a week now and maybe it went down by 50% :(
  4. diforce

    Darkvoice 336i & 336SE Tuberolling PartII

    Hey wonder if someone could help, i'm in the process of modding my DV 336se and I have several questions (it is connected to sen HD650 300ohm, will probably be replaced by beyerdynamics T1 gen2) 1. Performing the hum fitz mod for the cathode bridge, should I remove the 2 1k resistors while...
  5. diforce

    The Xonar Essence STX Q/A, tweaking, impressions thread

    How does the STX perform with low impedance phones such as Fostex T50 RP ? they are 50 ohms.    also does changing the OP AMPS to better ones actually makes it better ( aka it was tested on proper testing equipment )  or is it all audiophile voodoo ? 
  6. diforce

    which desktop amp for Fostex T50 RP ?

    more input anybody please ?:) 
  7. diforce

    which desktop amp for Fostex T50 RP ?

    I have thought about the M-stage ! but the output of the AUNE T1 MK2 is far greater , I thought because these phones can take the abuse of 3000mW , 1000mW would output more bass and "punch" because of more raw power , am I wrong ?    Right now , everything is bloody perfect after the mods...
  8. diforce

    which desktop amp for Fostex T50 RP ?

    Hi all, I need a amp recommendation for my Fostex T50RP phones.   My phones are modded (thunderpants I think), the mods added a LOT of detail but the bass went abit too sharp.   It ran on a TC electronic desktop konnect 6 mixer/dac/amp thingy , which gave it around 250mw .   Now i've read...
  9. diforce

    Fostex T50RP Amp\Dac advice

    how about the Asus Xonar STX ? I need it to be a DAC\AMP combo because amping the headphones to the thier full glory is not my highest priority , I just need a sound card or DAC to connect speakers to ... with some sort of "good" headphone amp .    
  10. diforce

    Different audio technica ATH-M50 amp question

    HI , Kinda new , Just subscribed to ask a question that i know have been asked 1000 times but its slightly different :) actually I read here for many years now ... so the audio technica ATH-M50 does not require an amp , I know this ... problem is I require a decent source , and my sound card ( m...
Top