Recent content by yiancar
-
Bijou All Tube Futterman Headphone Amplifier
I use 6H30 which i find to be more dominant(powerful) than the 6DJ8. Can we have a picture of or heater shielding?:)- yiancar
- Post #4,172
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
there is some, just an "extra" bit, you should try it out, u can leave it on minimum on one channel and remove it completely on the other. have u rolled any tubes?- yiancar
- Post #4,170
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
I assume u removed nfb?- yiancar
- Post #4,168
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
meaning construction or improvement ?:)- yiancar
- Post #4,166
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
only thing i cn suspect is faulty mosfets , however just to be sure can you also mesure the ac output voltage of the transformer as well as dc voltage between tube pin 3 and ground. just have ur meter ready, turn on get a mesurement turn off. dont replace the burned resistor, it doesnt matter...- yiancar
- Post #4,163
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
can u put tome quality pics of both the back and the front of the psu boards?- yiancar
- Post #4,161
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
You should not really be worried abt the mosfet being cooled. I have mine on the original position next to the tubes in an enclosure with little airflow and well they work fine. Stability is more abt "constant" heat than being cool ( assuming ur in the working temp range). Any way, no if u...- yiancar
- Post #4,159
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
Stupid me one of the heaters of the ecc99 was not connected...:@- yiancar
- Post #4,061
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
Suddenly one channel stopped working:S The problem is around the ecc99 circuit. Pin 1,2,3 of the ecc99 measure ~220v were pin 3 should have been ~120v. Pin 8 of the tube is at 0v instead of 2.2v. I changed the tube with a working one and still the same. Any idea which component might have...- yiancar
- Post #4,059
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
if you got any high voltage diodes around you can use them instead of the ps tube:)- yiancar
- Post #4,049
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
stupid me... cold connection on the heater pins. thanks for the idea :)- yiancar
- Post #4,041
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
measured the the coupling caps (c3 c4) they are fine. also checked pin 1-2-3 and they are not shorted, any other thoughts? also tried changing tubes. same problem- yiancar
- Post #4,040
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
got another problem again. i left the amp for quite some time on and one of the channels stop working, i feared it was the tubes so i interchanged them and still got no sound. i measured pin 1 - 2 -3 of the 6dj8 and they were all the same voltage , 184v i panicked . any idea whats causing this- yiancar
- Post #4,038
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
noticed that on one of my psus under load the maximum voltage i can get is ~245v the other runs fine at 250v sharp. checked input capacitors they are fine any idea what maybe causing this? can it be the transformer?- yiancar
- Post #4,036
- Forum: DIY (Do-It-Yourself) Discussions
-
Bijou All Tube Futterman Headphone Amplifier
will check the tubes as soon as i go home, i thought that the extention cable of the tubes may picking up noise i moved the tubes around and i get no difference so i guess i can rule that out. i get noise / hum on the left channel ( balanced amp btw) which is not affected by changing the...- yiancar
- Post #4,027
- Forum: DIY (Do-It-Yourself) Discussions