Xymordos's latest activity
-
Xymordos replied to the thread Home-Made IEMs.That's a really tidy desk :P -
-
I have the usound amp for a desktop / tuning solution, but planning to use the guts from some Fauna audio glasses for wireless and see...
-
Xymordos replied to the thread Home-Made IEMs.How did you power the MEMS?
-
KZ PR2 with usound UT-P2018 mems speaker, dry fit. There is a clear angle to drill and connect the sound bore.
-
Hi everyone I have been following the forum for a while now and I've been learning at lot about designing iems, I started with...
-
You went for a very complex build buddy :D 1. Drivers are as good as you implement them. Good tuning, acoustical design, and...
-
Xymordos replied to the thread Home-Made IEMs.Ooh I like this type of tuning. Listen to it yourself and see if you can hear it, personally I usually keep those peaks since I can't...
-
Hi, Diyer's friend ! Do I need to kill the peak at 17kHz ? or just leave it there ? Thanks all of your advice. Recently have finished...
-
Not sure if Vitaliy reads on here much these days, but I'm here all the time. Really interesting to see what you guys are cooking up.
-
I have the circuit figured out to where I can low pass the sub with parallel cap and not affect the other drivers. Need good sub bass...
-
This doubles as a biblically accurate angel.
-
Here’s a smattering of build designs from last year. My transparent shells are always a bit on the warm side of clear. Can never get...
-
Just sharing a clear build. :)
-
Today I'll finally know if I'm saying goodbye to WBFK :slight_smile:
