Where can one buy genuine replacement pads for the T1.2 in the US? The one place that comes up with actual Beyer pads when I search is in Europe.

It's ~6K and ~9.2K (probably just my variation of the ~8K spike) being affected by vertical and horizontal placement, respectively.

It doesn't have nearly the 6K spike of the HD800, but it's there. Or perhaps a more accurate description is it has relative dips at 5K and 7K, which cause a perceived spike at 6K, I don't know. It's also quite possible it's my ears, driver variability, or that I'm simply misremembering where I...

I've also noticed that placement of the headphones on the head makes a huge difference with the level of treble one hears, most likely an unfortunate side-effect of the angled driver. When I first got mine I was wearing them too low and too far back. I found that the vertical and horizontal...

Are there any established/definitive damping mods for the T1 (specifically 2nd gen)?

Just got these on xmas, running them through my crack w/speedball. I couldn't figure out why sometimes the treble on certain songs would spank my ears, and other times not so much. Then I happened to be running a sine wave at different frequencies and realized that there is a huge difference...

Gotcha.  thanks!

hmm, not locking, but how about this? Furutech FT-763.   or the version with carbon fiber, but I wouldn't get that unless the CF was for more than just looks.

managed to snag my headphone cord as I tried to run to the door to get my pizza and snapped the 1/4 plug on my DT880s.  Yep.  Anyways, I'm good for the soldering, just wondering if there's a particular replacement I should be grabbing.

shockwave crash caused double post. =/

Good find.  How does the II+ compare to the ODAC?  Is it worth the extra $45-55*?  I could only find comparisons between the ODAC and the non-plus version, which seemed to favor the ODAC.         *vs ODAC w/RCAs

Hello all,   Just finished my Crack + Speedball, which is sounding great with my DT880/600s, and now I want to pick up a USB DAC so I don't have to go through my soundcard.  I'm looking at picking up a revB ODAC but not sure if there might be a better choice under $200 (or at least close to...

As far as modeling clay is this fine?   http://www.amazon.com/Prang-Modeling-Colored-Blocks-Pounds/dp/B001AYYBEG/ref=sr_1_9?ie=UTF8&qid=1321406929&sr=8-9   I'm going to order a pair of the shure pads and figured I might as well get the clay too so I get the free shipping.     edit...

So far all I have done with mine is tape the stock pads to the cans to give them a proper seal and prevent them from slipping off the cans when I stuff the pads themselves, and I've stuffed a ~1 1/4 inch thick strip of fleece in both pads.  The strip overlaps itself for most of the back side of...

My T50RPs arrived today just as I was leaving for work.  Quickly took them out and I can already foresee me wanting to replace the stock earpads.  For now, though,  I want to see what I can do with 'em.  I picked up some upholstery velvet (noticeably thicker than some of the other velvets I saw)...